Instructions / Assembly

ManualsBrandsViqua ManualsKitchenUltraViolet Lamp

UV Lamp and Quartz Sleeve Replacement/Maintenance

Models: Tap, Tap Plus, Home, Home Plus, Professional, Professional Plus (Excluding, D4,

E4, F4, and Plus and Monitored versions)

Overview

UV Lamp replacement: The amount of UV light created by the UV lamp decreases over time, requiring that the UV lamp be

replaced. The system will automatically notify you when it is time to replace the UV lamp.

Quartz Sleeve replacement/maintenance: Minerals in the water slowly form a coating on the quartz sleeve. This coating must be

removed because it reduces the amount of UV light reaching the water, thereby reducing disinfection performance. If the quartz

sleeve can not be cleaned, it must be replaced.

Section 1 Safety Information

Please read this entire instruction sheet before operating this equipment. Pay attention to all danger, warning, and caution

statements in this instruction sheet. Failure to do so could result in serious personal injury or damage to the equipment.

Make sure that the protection provided by this equipment is not impaired. Do not use or install this equipment in any manner

other than that specified in the instruction sheet.

1.1 Safety Precautions

DANGER

Failure to follow these instructions will result in serious injury or death.

Shock Hazard - Stored Energy

• Disconnect pow

er to system before performing any maintenance or repair.

• Th

ere may be more than one source of power. Only connect to a GFCI.

• Prote

ctive ground

• DO NOT touch with wet hands.

Pressurized Device - Impalement Hazard

• NEVER perform any physi

cal inspection, repair or maintenance on UV chamber unless UV chamber has been isolated and depressurized.

• NEVER service UV lamp

s, quartz sleeves or associated hardware until depressurization of UV chamber has been confirmed.

• DO NOT store

any combustible or flammable material close to the system.

Instruction Sheet

520183-R_ RevF

Summary of content (5 pages)

PAGE 1
Instruction Sheet UV Lamp and Quartz Sleeve Replacement/Maintenance Models: Tap, Tap Plus, Home, Home Plus, Professional, Professional Plus (Excluding, D4, E4, F4, and Plus and Monitored versions) Overview UV Lamp replacement: The amount of UV light created by the UV lamp decreases over time, requiring that the UV lamp be replaced. The system will automatically notify you when it is time to replace the UV lamp.
PAGE 2
Safety Information WA R N I N G Failure to follow these instructions could result in serious injury or death. UV Light Hazard • ALWAYS use UV protective gear, including gloves and UV safety glasses. • NEVER look directly at illuminated UV lamp, even when using protective gear. • NEVER illuminate UV lamp outside of the UV chamber. • If accidental exposure occurs, immediately cool affected area and consult physician.
PAGE 3
Maintenance Section 2 Maintenance WA R N I N G • Always disconnect power before performing any work on the disinfection system. • Always shut-off water flow and release water pressure before servicing. • Replace the UV lamp annually (or biennially if seasonal home use) to ensure maximum disinfection. • Always drain the chamber when closing a seasonal home or leaving the unit in an area subject to freezing temperatures. 2.1 Replacing UV Lamp NOTICE Do not use water during replacement of UV lamp.
PAGE 4
Maintenance 2.2 Cleaning and Replacing Quartz Sleeve Note: Minerals in the water slowly form a coating on the quartz sleeve. This coating must be removed because it reduces the amount of UV light reaching the water, thereby reducing disinfection performance. If the sleeve can not be cleaned, it must be replaced. Prerequisites: • Shut off water supply and drain all lines. • Remove the UV lamp. Refer to Section 2.1.
PAGE 5
425 Clair Rd. W, Guelph, Ontario, Canada N1L 1R1 t. (+1) 519.763.1032 • tf. (+1) 800.265.7246 (US and Canada only) t. (+31) 73 747 0144 (Europe only) • f. (+1) 519.763.5069 e-mail: info@viqua.com www.viqua.