Instructions / Assembly

VIQUA Water Filters Installation and Replacement
Section 1 Safety Information
Please read this entire instruction sheet before operating this equipment. Pay attention to all danger, warning, and caution
statements in this instruction sheet. Failure to do so could result in serious personal injury or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this equipment in any manner
other than that specified in the instruction sheet.
1.1 Safety Precautions
Section 2 Installation
CAUTION
If water pipes are used to ground electrical system, appliances, or phone, install a jumper wire.
NOTICE
Read and understand this Instruction Sheet before operating and performing any maintenance on this equipment.
Warning: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
WARNING
• DO NOT install on line pressures above 85 psi (5.9 bar).
• DO NOT overtighten pipe fittings.
• DO NOT use wicking or sealer, Teflon™ tape is recommended.
• DO NOT use torch near plastic housing. All sweated joints should be made prior to assembling piping to the filter head.
• Replace O-ring seal, if there is visible damage. Ensure O-ring and threads are liberally lubricated with a silicone based lubricant.
• Operating temperature allowed is 4 - 38 °C (40 - 100 °F).
• Operating temperature range superseded by cartridge operating temperature if lower.
• Protect the filters from freezing temperatures.
• DO NOT install in direct sunlight.
• Allow minimum of 2” clear space under filter to facilitate cartridge change.
• DO NOT use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Instruction Sheet
520180-R_RevD