Owner's Manual

NPC is On/Off programmable, except doors are always covered

whether on or off. See your dealer and the Programming section of this

guide for more information.

Arming and disarming the system does not reset this function. In order to

reset a bypassed zone, the same zone must not trigger for 60 minutes,

or when ignition is turned on. If testing your system, it is important to

remember that the NPC programming can cause zones to be bypassed

and appear to stop working. If ﬁve chirps are heard when disarming,

NPC has been engaged. If you wish to clear the NPC memory, turn

the ignition key on.

Power Saver Mode

Your system will automatically enter Power Saver Mode while armed or

in Valet® Mode, after a period of time in which no operation has been

performed. This lowers the current draw to the vehicle’s battery. Power

Saver Mode takes over under the following conditions:

• Power Saver when the system is armed: After the system has

been armed for 24 hours, the control center LED will ﬂash

at half its normal rate, decreasing the system’s current draw.

• Power Saver in Valet Mode: When the system enters Valet Mode

the control center LED illuminates steadily. If the vehicle is not used

(ignition is not turned on) for a period of one hour while the system

is in Valet Mode, the LED will shut off. If the system remains in

Valet Mode, the LED will come back on the next time the ignition

is turned on and then back off.