A PROUD HERITAGE OF EXPERIENCE & QUALITY Dual-Zone Wine COOLER VT-DS24SBA149 (approx.149 Bottles) O W N E R ’ S M A N U A L W W W . V I N O T E M P .
General Operating Instructions Remove all external and internal packaging from your appliance. Be sure that all parts have been included before discarding any packaging materials. You may want to keep the box and packing materials for use at a later date. Upon receipt and inspection of unit, the supply cord must be replaced if it is damaged. Contact our customer service at 1-800-777-8466 or info@vinotemp.com. Let the unit rest UNPLUGGED for 24 hours once you have it placed in your home.
Table of contents Safety instructions and warnings ............................................................. 2 – 3 Transportation and unpacking ........................................................................ 4 Installation instructions ............................................................................. 4 – 6 Before installation of your appliance ........................................................ 4 Tools you will need .............................................................
Safety instructions and warnings IMPORTANT SAFETY INSTRUCTIONS WARNING: Before the appliance is used, it must be properly positioned and installed as described in this manual. So read the manual carefully. To reduce the risk of fire, electric shock or injury when using the appliance, follow basic precautions, including the following: To prevent injury or damage to the appliance, it should be unpacked and set up by two people. ■ Keep the room well ventilated.
Safety instructions and warnings Children in the household Grounding instructions DANGER, RISK OF CHILD ENTRAPMENT! Before you throw away your old appliance: Take off the door. Leave the shelves in place so that children may not easily climb inside. This appliance must be grounded. Never leave packaging material with children.
Transportation and unpacking If the appliance is transported in a horizontal position, the oil from the compressor may leak into the cooling circuit. For this reason, allow the appliance to rest in a vertical position for 12 hours before turning it on, so that the oil flows back into the compressor. Remove the external packaging, remove the protective plastic film from the surface of the appliance (if used) and clean the external parts of the appliance with a cleaner designed for this purpose.
Installation instructions FOR YOUR SAFETY While performing installations described in this section, gloves and safety glasses or goggles should be worn. Tools you will need: Installation dimensions (mm/in) If your appliance is to be built-in, follow the diagram and chart below for appropriate dimensions.
Installation instructions Model A B C D E VT-DS24SBA149 660mm (26″) 610mm (24″) 1813 mm (71 3/8" ) 230 mm (9 1/16 " ) 51mm (2″) Electrical requirements A 115 Volt (AC only) 60 Hz grounded electrical supply equipped with a 15- or 20- amp fuse or circuit breaker is required. It is recommended that a separate circuit serving only your appliance be provided. Use outlets that cannot be turned off by a switch or pull chain. Connect this appliance to a 3-prong power supply outlet that has a ground terminal.
Operation Operating conditions 3) “ ” button (left) Pressing this button will increase (warm) the temperature of the upper chamber in steps of 1°F (or 1°C). 4) “ ” button (left) Pressing this button will lower (cool) the temperature of the upper chamber in steps of 1°F (or 1°C). 5) LED display Displays temperature for the upper zone.
Operation Setting the temperature When you press the or button, the system will enter the set-up mode in the upper or lower compartment automatically. The LED will flash and display the setting temperature. When you press the button once, the temperature will increase or decrease by 1°F (or 1°C). If you try to go beyond the minimum/maximum value that can be established, the display will jump to the lowest/highest adjustable temperature value automatically.
Shelves REPLACING COLD CATALYST FILTER 1.Pull away the shelf in the area where the Do not cover racks with aluminum foil or any other material that will prevent adequate air circulation within the cabinet. To prevent damaging the door gasket, make sure to have the door all the way opened when pulling shelves out of the rail compartment. For easy access to the bottles, you must pull the shelves approximately 1/3 out of the rail compartment.
Operation Wine Storage Model:DS24SBA149 10
Cleaning and care Cleaning the appliance Wipe the internal surface of the appliance with a soft sponge lightly dipped in a table salt solution. Add 2 tablespoons of table salt to a quart of warm water. Wash the shelves in warm water with a small amount of kitchen dishwashing liquid, rinse and wipe dry. Allow the wooden shelves (if the appliance has them) to dry completely before returning them to the wine cooler.
Problems with your appliance? You can solve many common appliance problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. Please note the user can press and hold the temp down button(on the control panel) for approximately 3 seconds to show the “actual” temp for customer service to troubleshoot. Troubleshooting guide Problem Appliance does not operate. Possible cause Not plugged in.
Terms and Conditions Vinotemp International Corp. (“Seller”) and the person or entity that acquires these goods from Seller (“Purchaser”) hereby fully agree to the following terms and conditions of the sale: Shipping fees are the responsibility of the Purchaser whether freight prepaid or freight collect. Seller assumes responsibility for the goods sold to the Purchaser until the goods have reached Purchaser’s delivery address (FOB Destination) and the delivery receipt is signed clear.
Non-New Units (Scratch & Dent/Refurbished/Floor Models), warranty for compressor units is 90 days from your dated invoice and 30 days for thermoelectric units (parts for function only, not cosmetic defects). These units are refurbished and sold as is; Purchaser assumes risks to the quality and performance of goods and assumes the costs of all necessary service or repair not covered herein. Extended warranties via New Leaf may not be purchased on Non-New Units. Delivery is curbside.
SERVICE & IMPORTANT NOTICE Upon receipt and inspection of unit, the supply cord must be replaced if it is damaged. Contact our customer service at 1-800-777-8466 or info@vinotemp.com. The manufacturer has a policy of continuous improvement on its products and reserves the right to change materials and specifications without notice. WARNING: Please do not place the unit within reach of children. For adult use only. Contact info@vinotemp.com with any questions or visit: www.vinotemp.com 17621 S.