Operating instructions

8
8
W W W . V I N O T E M P . C O M
INSTALLATION INSTRUCTIONS
Before using your wine cellar:
 Remove the exterior and interior packing.
 Check to be sure the following parts are included:
o 6 Slide out shelves
o 1 Instruction manual
 Before connecting the appliance to the power source, let it stand upright
for approximately 24 hours. This will reduce the possibility of a
malfunction in the cooling system from handling during transportation.
 Clean the interior surface with lukewarm water using a soft cloth before
first use.
How to install your handle:
 Open the door
 Gently remove gasket (seal) from door frame
 Insert both handle screws into the designated holes
 Place the handle against opposite side of the door and line up handle with
screws
 Use a screwdriver to fasten together (Do NOT over tighten)
 Replace gasket into the door frame
POSITIONING YOUR WINE CELLAR
 Place your appliance on a floor or other solid, flat surface that is strong
enough to support the appliance when it is fully loaded. To level your
appliance, adjust the front legs at the bottom of the appliance.
 Cellar must be placed as a freestanding unit—not to be built in.
 When positioning the wine cooler, ensure that there is at least a 2 inch (5
cm) clearance at the sides and a 4 inch (10 cm) clearance at the back of
the cooler as this is the main outlet for heat. This will allow for adequate
ventilation.
 For proper installation, keep away from direct sunlight and sources of
heat (stove, heater, radiator, etc.). Direct sunlight may affect the coating
and heat sources may increase electrical consumption. Extreme cold or
hot ambient temperatures may cause the appliance not to perform
properly.
 Not designed for placement in garage or basement. Designed for indoor,
home use only.