Installation Sheet

12
12
WWW.VINOTEMP.COM
NOTE: All parts removed must be saved to allow the door swing to be reversed.
1. Remove the bottom hinge (2) by unscrewing the four lock screws (1). Be careful to hold
the door firmly after removing the screws. (Fig. 1)
2. Gently pull down to remove the door from the right top hinge and place it on a padded
surface to avoid the risk of damage. Then remove the right top hinge (4). (Fig. 3)
3. Unscrew and transfer pin (3) of the hinge plate to the opposite side. (Fig. 2)
4. Pop out the cover caps on the left side of the cabinet and use them to cover the screw
holes on the right hand side.
5. Screw the alternative left top hinge (6), included in the fittings, on the left hand side of the
cabinet. (Fig. 3)
6. Rotate the door 180° and relocate it to the designated position. Then screw the bottom
hinge assembly on the left designated position and tighten it after the door is leveled. (Fig.
4)
OPERATING YOUR APPLIANCE
CONTROLS
ON/OFF Power
To turn the appliance off, press and hold the key for 5 seconds until temperature
display goes out. To turn the appliance on, press and hold the key for 1 second until
temperature display lights up. NOTE: Pressing the POWER key once can switch off the
audible alarm when the alarm is on.