Installation Sheet

3
IMPORTANT – Please Read and Follow!
• Make sure that incoming voltage is the same as unit rating. An electric
rating plate specifying voltage, frequency, wattage, amperage, and
phase is attached to the product.
• To reduce the risk of  re, electrical shock, or injury to persons,
installation work and electrical wiring must be done by a quali ed
technician in accordance with all applicable codes and standards,
including  re-rated construction.
• The installer should leave these instructions with the consumer who
should retain them for local inspector’s use and for future reference.
For additional information or installation videos, visit our website at
www.vikingrange.com
DANGER
WARNING
You will be killed or seriously injured if you
don't follow instructions.
You can be killed or seriously injured if you
don't follow instructions.
All safety messages will identify the
hazard, tell you how to reduce the chance
of injury, and tell you what can happen if
the instructions are not followed.
Your safety and the safety of others is very
important.
We have provided many important safety
messages in this manual and on your appliance.
ALWAYS read and obey all safety messages.
This is the safety alert symbol. This
symbol alerts you to hazards that
can kill or hurt you and others.
All safety messages will be preceded by the
safety alert symbol and the word “DANGER” or
“WARNING.” These words mean:
It is your responsibility to:
• comply with installation speci cations and dimensions.
• properly install unit.
• remove any moldings or decorative panels that prevent the unit from being serviced.
• make sure that you have these materials (not provided with your unit), which are necessary
for proper installation:
• 1/4” (6 mm) copper tubing with shuto valve
• 1– Saddle valve (do not use self-piercing feature of the valve)
• assure that  oor will support unit, door panels and contents (approximately
1200 pounds [540 kg]).
• provide a properly grounded electrical outlet.
• assure that location will permit appliance doors to open 90º minimum.
Required tools
• Drill
• Drill bits - 3" Phillips (Ph2), Torx (T15 & T20), 1/4" and 5/16" hex drive
• Rubber mallet
• 3/8" wrench