Installation Sheet

10
MODEL VG06041
PLATE
HEX
SCREW
BRACKET
BODY
B3
PLATE
15
17
3. Remove the wall mount bracket assembly
(#1) from the structural rail assembly.
Unthread the plate from the bracket
assembly body.
There is a 13mm adjustment
built into the plates for minor modifications.
4. Place plates to the wall over the plastic
anchors. Screw plates in with 1 5/8" screws
(#15).
5. Place the fixed panel bottom clip (#7) and the
door bottom guide (#8) to the marked
locations on the floor. Drill the holes and
place the plastic anchors (#16) inside them.
Screw in the fixed panel bottom clip and the
door bottom guide to the floor with 1 1/8"
screws (#18). Note for applications where
screws are not applicable the use of
epoxy is highly recommended. Refer to the
type of material you are mounting to for the
correct style of epoxy as it is specific to
material (not provided). Epoxy should only be
used on the fixed panel bottom clip and the
bottom door guide. Proceed to Step 6 if this is
your style of installation.
13mm
B4
B5
18
16
7
18
8
BRACKET
BODY
PLATE