User Guide

30
Correcting keystone
Keystoning refers to the situation where the projected image becomes a trapezoid due to
angled projection.
To correct this, besides adjusting the height of the projector, you will need to manually
correct it following one of these steps.
• Using the remote control
1. Press /// to display the Keystone
correction page.
2. Press to correct keystoning at the top of
the image. Press to correct keystoning at
the bottom of the image. Press to correct
keystoning at the right side of the image.
Press to correct keystoning at the left side
of the image.
• Using the OSD menu
1. Open the OSD menu and go to the
DISPLAY > Keystone > Manual menu.
2. Press Enter.
3. Press to correct keystoning at the top of the image or press to correct
keystoning at the bottom of the image. Press to correct keystoning at the right side
of the image. Press to correct keystoning at the left side of the image.
The projector can automatically correct vertical keystone. To do this, open the OSD menu
and go to the
DISPLAY > Keystone > Auto V Keystone and press / to select On.
Adjusting 4 corners
You can manually adjusts the shape and size of an image that is unevenly rectangular on all
sides.
1. To display the Corner Adj. page, you can do
one of the followings:
i. Press Enter.
ii. Open the OSD menu and go to the
DISPLAY > Corner Adj. menu and
press Enter. The Corner Adj. page is
displayed.
2. Press / / / to select the corner you
wish to adjust and press Enter.
Press /
Press /
Press / Press /
A long press for 2 seconds on
Enter when this page displays
will reset the settings on all 4
corners.