User Guide
10
Using the remote control cursor
Use the remote control to operate your computer during presentations for greater exibility
1. Before using the remote control to replace your cursor, x one end of the USB cable
to the projector Mini USB port and the other end to the PC or notebook computer.
See “Connect to the computer” for details.
2. Change the input signal to D-Sub or HDMI via PC source.
3. Press the [Mouse] button on the remote control to switch from Normal Mode to
Cursor Mode. The screen will display an icon that indicates Cursor Mode has been
activated.
4. Achieve mouse cursor functions through using your remote.
• To move the cursor on screen, please press ///.
• To make a single click with the Left Mouse Button, please press
.
• To make a single click with the Right Mouse Button, please press
.
• To use the displayed software (such as Microsoft PowerPoint) of the connected
computer, press PgUp/PgDn to go to the previous page or the next page.
• To return to Normal mode, press the [Mouse] button again or press other functional
buttons not related to the mouse functions.
Remotecontroleectiverange
There is an infra-red (IR) remote control sensor located at the front of the projector. Hold
the remote control and maintain a perpendicular angle within 30 degrees with the IR
remote control sensor to achieve normal remote control functions. The distance between
the remote control and the sensor should not exceed 8 meters (about 26 feet).
Do not place any obstruction in front of the IR sensor
on the projector as this may block the IR beam.
Approx. 30°