Blue Smart IP67 Charger Waterproof

www.victronenergy.com
Victron Energy B.V. | De Paal 35 | 1351 JG Almere | The Netherlands
General phone: [phone] | Fax: [phone]
E-mail: [e-mail] |
www.victronenergy.com
Blue Smart IP67 battery charger 12/7 12/13 12/17 12/25 24/5 24/8 24/12
Input voltage range and frequency 180-265 VAC 45-65 Hz
Efficiency 93% 93% 95% 95% 94% 96% 96%
No load power consumption 0.5W
Charge voltage 'absorption' Normal: 14,4V High: 14,6V Li-ion: 14,2V Normal: 28,8V High: 29,2V Li-ion: 28,4V
Charge voltage 'float' Normal: 13,8V High: 13,8V Li-ion: 13,35V Normal: 27,6V High: 27,6V Li-ion: 26,7V
Charge voltage ‘storage’ Normal: 13,2V High: 13,8V Li-ion: n. a. Normal: 26,4V High: 26,4V Li-ion: n. a.
Charge current, normal mode 7A 13A 17A 25A 5A 8A 12A
Charge current, LOW 2A 4A 6A 10A 2A 3A 4A
Charge algorithm 4-stage adaptive
Can be used as power supply yes
Protection Battery reverse polarity (fuse) Output short circuit Over temperature
Operating temp. range -20 to +60°C (full rated output up to 40°C) Derate 3% per °C above 40°C
Humidity Up to 100%
Start interrupt option (Si)
Short circuit proof, current limit 0,5 A
Output voltage: max one volt lower than main output
ENCLOSURE
Material & Colour aluminium (blue RAL 5012)
Battery-connection Black and red cable of 1,5 meter
230 V AC-connection Cable of 1,5 meter with CEE 7/7 plug
Protection category IP67
Weight (kg) 1,8 1,8 2,4 2,4 1,8 2,4 2,4
Dimensions (h x w x d in mm) 85 x 211 x 60 85 x 211 x 60 99 x 219 x 65 99 x 219 x 65 85 x 211 x 60 99 x 219 x 65 99 x 219 x 65
STANDARDS
Safety EN 60335-1, EN 60335-2-29
Emission Immunity EN 55014-1, EN 61000-6-3, EN 61000-3-2
Automotive Directive EN 55014-2, EN 61000-6-1, EN 61000-6-2, EN 61000-3-3
Bluetooth Smart enabled
The Blue Smart IP67 Battery Charger is thé wireless solution to monitor voltage and current, to change settings and to
update the charger when new features become available.
With Bluetooth, the functionality of the IP67 charger is enhanced and is similar to that of our IP22 and IP65 chargers.
Completely encapsulated: waterproof, shockproof and ignition protected
Water, oil or dirt will not damage the Blue Smart IP67 Battery Charger. The casing is made of cast aluminium and the
electronics are moulded in resin.
The highest efficiency ever!
Setting a new industry standard: with 92% efficiency or better, these chargers waste three to four times less heat.
And once the battery is fully charged, power consumption reduces to less than a Watt, some five to ten times better
than the industry standard.
Adaptive 5-stage charge algorithm: bulk – absorption – recondition – float – storage
The Blue Smart Charger features a microprocessor controlled ‘adaptive’ battery management. The ‘adaptive’ feature
will automatically optimise the charging process relative to the way the battery is being used.
Storage Mode: Less maintenance and aging when the battery is not in use
The storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In the storage
mode float voltage is reduced to 2,2 V/cell (13,2 V for a 12 V battery) to minimise gassing and corrosion of the positive
plates. Once a week the voltage is raised back to the absorption level to ‘equalize’ the battery. This feature prevents
stratification of the electrolyte and sulphation, a major cause of early battery failure.
Also charges Li-ion (LiFePO₄) batteries
LiFePO₄ batteries are charged with a simple bulk – absorption – float algorithm.
Protected against overheating
Can be used in a hot environment such as a machine room. Output current will reduce as temperature increases up to
60°C, but the charger will not fail.
Two LEDs for status indication
Yellow LED: bulk charge (blinking fast), absorption (blinking slow), float (solid), storage (off)
Green LED: power on
Blue Smart IP67 Battery Charger
180-265 VAC
Blue Smart IP67 Charger 12/25