Full Product Manual

Installing the Tipping Restraint helps to prevent the unit from tipping over.

* One tipping restraint package includes 1 safety strap, 2 brackets, 2 anchors and 4 screws.

Installing the Tipping Restraint Pack

1. Determine the unit’s location in the room.

2. Figure out the placement of the tipping restraint bracket on the wall and mark the screw holes.

3. Use a small drill bit (not included), about 1/16 inch, and drill a small pilot hole to see if there is

a stud on the wall. If there is a stud, use the included long screws to attach the bracket to the wall.

(If there is no stud in the wall, drill a hole with a larger 1/4 inch drill bit (not included) and install the

included anchors.)

4. On the back of the unit, a bracket will need to be attached. To do this, temporarily move the

unit to its nal position and mark the location of the bracket on the unit.

5. Move the unit away from the wall and drill a pilot hole with a drill bit (not included) about

1/16 inch. Attach the bracket to the unit with the short screws (included).

6. Move the unit into its nal position, taking care to line up the wall brackets with the unit brackets.

Thread the safety strap (included) through the brackets as shown in picture-6 below. Tighten straps

until snug. Do not overtighten.

7. Check to be sure that the wall brackets are rmly screwed into the wall, and the unit brackets are

rmly attached to the frame, and the straps are snug.

MARK THE WALL

Safety Strap X 1

Anchors X 2 Brackets X 2

Screws X 4

DRILL HOLES

ATTACH BRACKET TO FURNITURE TIGHTEN STRAPS TO SECURE

INSTALL ANCHOR INSTALL SCREW

INSTALLING THE TIPPING RESTRAINT