Manual

Chapter 7 Connectivity
Stratasync
80 User Manual 7SMART102 Rev006
Pre-requisites for using the Stratasync with the SmartOTDR
The user must have subscribed to Stratasync, and by consequence, he must have
acquired an account Identifier and a password.
The Ethernet and Proxy parameters must have been correctly configured in the System
Settings page of the SmartOTDR (see “Ethernet > Mode” on page 55 and “Proxy > Use
proxy” on page 56).
Configuring and synchronizing the SmartOTDR
The SmartOTDR can be configured to be synchronized with the Stratasync.
1 On the Home page, press Connectivity.
2 Check the configuration of the Ethernet and Proxy parameters (see “Configuring
the SmartOTDR via Ethernet” on page 54
3 In the Connectivity windows, press Stratasync .
4 Configure the Stratasync parameters:
a In
the Server Type parameter, the Viavi Server is selected by default and it
is recommended to keep this parameter.
However, the user can select if necessary the Server Name parameter and
enter the name in the following parameter.
b In the Account ID parameter, enter the same identifier as the one used to
access to Stratasync.
c The Technician ID parameter is automatically fulfilled after synchronization
(if it has been defined by the administrator of the Stratasync)
d To upload the files from a directory onto the SmartOTDR toward Stratasync,
select the parameter Upload from and press right arrow key to enter the
directory path (example: disk/Stratasync). The directory Stratasync is
defined by default.
Figure 64 Stratasync configuration