330C-HG - 200PSI COMPRESSOR KIT IMPORTANT SAFETY INSTRUCTIONS CAUTION - To reduce risk of electrical shock or electrocution: - Do not disassemble. Do not attempt repairs or modifications. Refer to qualified service agencies for all service and repairs. - Do not use this product in an area where it can fall or be pulled into water or other liquids. - Do not reach for this product if it has fallen into liquid. - Use this compressor with 12-volt DC systems only.
30C-HG - 200PSI COMPRESSOR KIT MOUNTING AND WIRING 1. Disconnect ground cable from 12-volt power source. 2. Temporarily position the air compressor in the location where it will be mounted. 3. Route ground wire to the negative post of the battery or to an appropriate grounding point and cut ground wire to length as needed. 4. Mount air compressor with the four sets of bolts, nuts, washers, and locking washers provided. (See Mounting Instructions) Use of thread sealant is recommended. 5.
330C-HG - 200PSI COMPRESSOR KIT OPERATING INSTRUCTIONS 1. IMPORTANT: Always operate the compressor at or below the MAXIMUM PRESSURE RATING of the compressor. Please refer to Application & Specifications Sections of this manual for details. 2. Always observe the MAXIMUM DUTY CYCLE of the air compressor. Refer to Compressor Applications and Specifications Sections of this manual for details. Operation exceeding maximum pressure ratings and/or duty cycle will result in damage to the air compressor. 3.
330C-HG - 200PSI COMPRESSOR KIT USER MANUAL
330C-HG - 200PSI COMPRESSOR KIT COMPRESSOR APPLICATION GUIDE To ensure that you get the highest level of satisfaction from your compressor’s performance, refer to information below: VIAIR COMPRESSOR REFERENCE CHART COMPRESSOR SERIES MAX.
330C-HG - 200PSI COMPRESSOR KIT TROUBLESHOOTING GUIDE: Tank pressure drops when 1. Loose drain cock compressor (s) shut off 2. Check valve leaking 3. Loose connections 1. Tighten drain cock 2. Replace check valve or compressor(s) 3. Check all connections with soap and water solution and tighten Compressor runs continuously and air flow lower than normal 1. Excessive air usage 2. Loose connections 3. Worn piston ring or inlet valve. 4. Clogged air filter element 1. Decrease air usage 2.
330C-HG - 200PSI COMPRESSOR KIT AMERICAN WIRE GAUGE GUIDE 12-VOLT: AMERICAN WIRE GAUGE GUIDE 24-VOLT: Amp Draw Length of wire from battery to compressor (in feet) Amp Draw 5 10 15 20 25 30 40 50 60 5 16 16 16 14 14 12 12 10 10 5 10 15 20 25 30 40 50 60 10 16 14 12 10 10 10 8 6 6 15 16 12 10 10 8 8 6 6 4 20 14 10 10 8 6 6 6 4 4 Length of wire from battery to compressor (in feet) 5 16 16 16 16 16 16 14 14 12 10 16 16 16 14 12 12 10 10 10 15 16 16 14 12 12 10 10 8 8 20 16 14 12 10 10 10 8 6 6 Wi