User's Manual

EVX-S24 OPERATING MANUAL 13
OPERATION
Preliminary Steps

Install a battery pack into the transceiver and charge
the battery fully, as described previously.

Screw the supplied antenna onto the Antenna jack, as
described previously.
It is not recommended to operate this transceiver with-
out an antenna connected.

If you have a Speaker/Microphone, we recommend
that it not be connected until you are familiar with the
basic operation of the
EVX-S24
. Refer to next page
for more information about Speaker/Microphone us-
age.
IMPORTANT NOTE
The dust- and waterproof rating of the transceiver
(IP67) is assured only when the following condi-
tions are met:

Battery Cover is attached to the transceiver;

Antenna is connected to the antenna jack;

Rubber Cover is installed over the
Micro USB
jack.

MIC/SP
cap is installed in the
MIC/SP
jack.
Or the Speaker/Microphone that approved with
an IP67 rating by Vertex Standard is installed in
the
MIC/SP
jack.
Operation Quick Start

Turn the top panel’s
VOL/PWR
knob clock-
wise to turn on the radio.

Press the
[

]
/
[

]
key to choose the desired operating
channel.
If you want to select the
operating channel from a
different Channel Group,
press (or press and hold)
the Programmable key
(assigned to the “Group
Up/Down” function) to change desired Channel Group
before selecting the operating channel.

Rotate the
VOL/PWR
knob to set the volume
level.
Exhibit 8: Operating Manual
FCC ID: AXI11464620
IC: 10239A-11464620
Vertex Standard LMR, Inc.