Installation Manual

ManualsBrandsVerona ManualsCooking Appliances12 Inch Electric Cooktop with 2 Radiant Elements, Ceramic Glass Surface, Residual Heat Indicator Light, Power On Indicator Light, Control Knobs, and Stainless Steel Frame: 230 Volt

IMPORTANT - PLEASE READ AND FOLLOW

✓ Before beginning, please read these instructions completely and carefully.

✓ Do not remove permanently affixed labels, warnings, or plates from the product. This

may void the warranty.

✓ Please observe all local and national codes and ordinances.

✓ Please ensure that this product is properly grounded.

✓ The installer should leave these instructions with the consumer who should retain

for local inspector's use and for future reference.

✓ The electrical connection should always be accessible

Electrical installation must be in accordance with the National Electrical Code,

ANIS/NFPA70 - latest edition and/or local codes.

IN CANADA: Electrical installation must be in accordance with the current CSA C22.1

Canadian Electrical Codes Part 1 and/or local codes.

BUILT-IN

CERAMIC

COOKTOP

• USERS OPERATING INSTRUCTIONS

• INSTALLATION ADVICE

Model VEECT212F..

Summary of content (12 pages)

PAGE 1
B U I LT- I N CERAMIC COOKTOP Model VEECT212F.. • USERS OPERATING INSTRUCTIONS • INSTALLATION ADVICE IMPORTANT - PLEASE READ AND FOLLOW ✓ Before beginning, please read these instructions completely and carefully. ✓ Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty. ✓ Please observe all local and national codes and ordinances. ✓ Please ensure that this product is properly grounded.
PAGE 2
Dear Customer, Thank you for having purchased and given your preference to our product. The safety precautions and recommendations reported below are for your own safety and that of others. They will also provide a means by which to make full use of the features offered by your appliance. Please preserve this booklet carefully. It may be useful in future, either to yourself or to others in the event that doubts should arise relating to its operation.
PAGE 3
USER INSTRUCTIONS IMPORTANT PRECAUTIONS AND RECOMMENDATIONS ✓ After having unpacked the appliance, check to ensure that it is not damaged. If you have any doubts, do not use it and consult your supplier or a professionally qualified technician. ✓ Packing elements (i.e. plastic bags, polystyrene foam, nails, packing straps, etc.) should not be left around within easy reach of children, as these may cause serious injuries. ✓ The packaging material is recyclable and is marked with the recycling symbol .
PAGE 4
features SCHOTT 2 1 5 6 7 4 3 5 8 10 4 3 11 2 9 2 1 6 7 9 10 11 1 12 8 12 OFF OFF Fig. 1.1 3 5 7 6 4 VITROCERAMIC HOB (Fig. 1.1) Electrical insulation Class I COOKING POINTS 1. Zone Ø 145 - 1200 W 2. Zone Ø 180 - 1700 W CONTROL PANEL DESCRIPTION 3. Rear zone control knob 4. Front zone control knob 5. Rear zone residual heat indicator 6. Front zone residual heat indicator 7.
PAGE 5
using the vitroceramic hob VITROCERAMIC HOB The main characteristic of this pyroceram cooker top is that it permits rapid vertical transmission of the heat from the heating elements below to the saucepans on top. The heat does not spread horizontally, however, and therefore the glass stays cold only a few centimetres from the hob. The hobs are controlled by the continuous energy regulation switch (0÷12) (fig. 2.1). The heat intensity can be regulated continuously from “OFF” to “12” (max).
PAGE 6
HINTS FOR SAFE USE OF THE HOBS – Before switching on, check which knob controls the required hob. You are advised to place the saucepan on the hob before switching on and to take it off after switching off. – To switch on, always lightly press the control knob then turn it. – Use saucepans with an even flat bottom (be careful of cast iron saucepans). Uneven bottoms can scratch the pyroceram surface. Check that the bottom is clean and dry.
PAGE 7
cleaning and maintenance GENERAL RECOMANDATION ✓ Before you begin cleaning you must ensure that the hob is switched off. It is advisable to clean when the appliance is cold and especially when cleaning the enamelled parts. ✓ All enamelled surfaces have to be washed with soapy water or some other nonabrasive product with a sponge and are to be dried preferably with a soft cloth. ✓ Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on the surfaces.
PAGE 8
INSTALLATION INSTRUCTIONS WARNING! THIS APPLIANCE HAS TO BE INSTALLED BY A QUALIFIED INSTALLER. Improper installation, adjustment, alteration, services, or maintenance can cause injury or property damage. Consult a qualified installer, service agent, or the gas supplier. GENERAL INFORMATION 1. Installation must conform with local codes. 2. WARNING: This appliance shall not be used for space heating. This information is based on safety considerations. 3.
PAGE 9
COOKTOP DIMENSIONS 24” (610 mm) 20” 1/16 (510 mm) (CUT-OUT) 19” 9/32 (490 mm) 2” 23/64 (60 mm) 1” 31/32 (50 mm) installation to the cabinet 11” 21/64 (288 mm) 7 5 8 9 11 1 12 OFF 6 7 4 3 8 9 2 11 1 2” 23/64 (60 mm) BOX DIMENSIONS 1” 31/32 (50 mm) 6 2 min 3” (76.
PAGE 10
PROXIMITY TO SIDE CABINETS 1. The cooktop may be installed directly to existing base cabinets. 2. The cooktop CANNOT be installed directly adjacent to sidewalls, tall cabinets, tall appliances, or other side vertical surfaces. There must be a minimum of 3” (76.2 mm) side clearance (left or right) from the cooktop cut-out to such combustible surface above the counter heigh. IMPORTANT: ONE SIDE (LEFT OR RIGHT) ABOVE THE COUNTER HEIGHT MUST AWAYS BE KEPT CLEAR. 3.
PAGE 11
electrical connection This appliance must be connected to a grounded, metallic permanent wiring system or a ground connector should be connected to the ground terminal or wire lead on the cooktop. This appliance is manufactured with a frame connected, green or bare ground wire. Connect the cooktop cable to the junction box through the CSA or UL-listed conduit connector. Complete electrical connection according to local codes and ordinances.
PAGE 12
The manufacturer cannot be held responsible for possible inaccuracies due to printing or transcription errors in the present booklet. The manufacturer reserves the right to make all modifications to its products deemed necessary for manufacture or commercial reasons at any moment and without prior notice, without jeopardising the essential functional and safety characteristics of the appliances.