User guide

35
• There is only one orientation that the Vehicle Diagnostics Module will plug in.
• Place two ngers behind the plug in your vehicle to prevent it from moving while plugging in
the Module.
• If the Module protrudes into the knee or foot area or prevents an access panel door from
closing, Vehicle Diagnostics Relocation Kit may be used to relocate the Module. See
connectedcar.delphi.com/fitment for recommendations on using a relocation kit with your
vehicle.
• Wait for the Status LED to turn solid blue.
• To minimize drain on the vehicle battery, the “Install Your Vehicle Diagnostics Module” and
“Initiate Vehicle Diagnostics Module Setup” steps should be performed without interruption.
The process will take less than 5 minutes.
Note: The Status LED will remain dark for approximately 30 seconds. When vehicle setup is
successfully completed, the Status LED will turn solid blue.
Note: To avoid any unnecessary drain on the vehicle battery, it is recommended to not leave the
Vehicle Diagnostics Module in the solid blue state for more than 24 hours.
Initiate Vehicle Diagnostics Module Setup
Stop! Do not proceed until the Status LED is solid blue, indicating activation on the Verizon
network is complete.
1. Insert your vehicle’s ignition key and turn it to the On position (not ACC/Accessory). Do not
start the engine!
Note: Typically, all of the warning lamps on the dashboard will illuminate briefly in this position.
Note: For pushbutton-start vehicles, the procedure is typically to push the start button without
your foot on the brake (check your vehicle owner’s manual to determine how many presses are
required to turn the ignition on).