User guide
31
Helpful Installation Tips:
• If the Vehicle Diagnostics Module seems to be difcult to insert, DO NOT FORCE IT. Remove
the device and examine both connectors for any bent pins.
• There is only one orientation that the Vehicle Diagnostics Module will plug in.
• Place two ngers behind the plug in your vehicle to prevent it from moving while plugging in
the Module.
• If the Module protrudes into the knee or foot area or prevents an access panel door from
closing, Vehicle Diagnostics Relocation Kit may be used to relocate the Module. See connect-
edcar.delphi.com/fitment for recommendations on using a relocation kit with your vehicle.
• Wait for the Status LED to turn solid blue.
• To minimize drain on the vehicle battery, the “Install Your Vehicle Diagnostics Module” and
“Initiate Vehicle Diagnostics Module Setup” steps should be performed without interruption.
The process will take less than 5 minutes.
Note: The first time the Module connects to the Verizon network, it will perform a one-time network setup
which will take a few minutes. The Status LED will turn solid white then turn off, followed by a blinking white
sequence. When network setup is successfully completed, the Status LED will turn solid blue. See
Understanding the Status LED for more information on the LED color status.
Note: To avoid any unnecessary drain on the vehicle battery, it is recommended to not leave the
Vehicle Diagnostics Module in the solid blue state for more than 24 hours.
Initiate Vehicle Diagnostics Module Setup
Do not proceed until the Status LED is solid blue, indicating activation on the Verizon network is
complete.
1. Insert your vehicle’s ignition key and turn it to the On position (not ACC/Accessory). Do not
start the engine!