Installation Guide

11
a. Remove the hinge bolts from the bottom
brackets. Remove the bottom brackets from the
bracket bases, and insert the bottom brackets
into each end of the bottom rail (Fig. 14).
b. Slide the bottom bracket (and rail) into the
bottom mounting base while setting the top rail
on top of the top rail bracket.
c. Reinsert the hinge bolt through the bottom
brackets to lock assembly into place.
Hinge Bolt
Top Bracket
Fig. 14
7.
Fig. 15
Connect Rails to Brackets:
a. Press top rail bracket end covers onto each
end of the top rail cap that was previously cut.
Press down on the top rail cap to ensure that it
ts snug onto the panel and that the top rail end
bracket covers are being held in place by the
line bracket (Fig. 15).
b. Using the holes in the bracket as a guide, pre-
drill two (2)
1
⁄8 " holes from under the bottom of
the rail up through the top rail. Drive two (2) 1
5
⁄8 "
screws up through the hole locking the bracket,
panel and top rail together, being careful not to
drill through the top of the top rail (Fig. 16).
c. Install pyramid post top onto each post (Fig.17).
NOTE:
A rubber mallet may be needed for a proper t.
Fig. 16
Fig. 17
Pyramid TopPyramid Top
PostPost
8.