Installation Guide

Place a deck board on the stair noses spanning from

post to post. Place the stair panel on the board across

the opening and plumb balusters while ensuring equal

spacing on each end. Clamp the panel in place at this

location (Fig. 2).

NOTE:

Use the proper deck board thickness to result in the

desired nished rail height.

Fig. 2

Clamps

Deck

Board

Stair PanelStair Panel

Temporarily assemble top and bottom stair mounting

brackets. Brackets slide into bracket bases, bracket

cover is aligned, and the bracket is fastened together

using the hinge bolt provided (Fig. 3 & 4).

a. Hold each respective bracket (angled) against the

post face, align bracket with stair panel and mark all

four (4) ends of the rail panel (Fig. 5).

b. Repeat this on the opposite side of the panel and be

sure to label the top rail to simplify placement after

cutting.

Stair Bracket Base

Top Bracket

Bracket Cover

Bottom Bracket

Hinge Bolts

Fig. 3

Fig. 4

Fig. 5

a. For the bottom rail only, add

⁄4

" (toward the rail end or

post) to the marks made on the panel in step 3 (Fig. 6)

and cut the panel at these marks.

b. For the top rail, cut the panel directly on the marks

made in step 3. Insert the bottom brackets onto

bottom rail, align top brackets (temporarily secure

brackets in place with tape), and test the panel for

proper t.

c. Once proper t is ensured, mark the bracket positions

at all four (4) locations (Fig. 7) and remove brackets

from the rail panel.

3/4"

Fig. 6

Fig. 7