Installation Guide

9
a. Pre-drill the top rail at the bottom stair post
using the bracket holes as a guide (Fig. 13).
b. Drive two (2) 1
5
⁄8 " painted pan head screws up
through the holes locking the bracket, panel and
top rail together. Once the top rail is secured,
tighten all four (4) of the hinge bolts to lock stair
panels in place.
Install pyramid post top onto each post (Fig. 14).
NOTE:
A rubber mallet may be needed for a proper t.
Pre-drillPre-drill
Fig. 13
Fig. 14
Pyramid TopPyramid Top
PostPost
10.
11.
NOTE:
Angle rail installation uses a combination of
features used in both the rail and stair
applications. This installation will use the same
bracket base of the stair brackets and similar
components, while using the preset layout of the
installation template for quick and easy
installation.
Angle rail brackets must be purchased separately.
Angle rail mounting varies greatly on each
installation.
ANGLE RAIL INSTALLATION
1.
a. Remove template from rail kit.
Refer to angle bracket components (Fig. 1).
b. Align bottom of template with top of the base
trim and secure in place with a piece of tape or
rubber band.
c. Follow instructions on template for pre-drilling
using a
1
⁄8 " drill bit, then remove the template.
d. Align top and bottom bracket bases with covers
attached (Fig. 2) with the holes ensuring that
they are square. Fasten bracket bases in place
using the non-painted at head 1
1
⁄2 " screws
provided.
Bottom Bracket
Stair Bracket Base
Bracket
Cover
Hinge Bolts
Top Bracket
Fig. 1
Fig. 2
Pre-Drill
Stair Bracket
Base
2.