Installation Guide

Attaching Bottom Rail Bracket Cover:

Test t the rail panel. Once proper t is ensured,

press bottom bracket covers onto the ends of

the bottom rail (Fig. 11) and set panel in place on

brackets.

Connect Rails to Brackets:

a. Press top rail cap and bracket covers onto the

top rail that was cut in step 1 onto the top of the

panel. Press down on the top rail cap to ensure

that it ts snug onto the panel and that the top

rail bracket end covers are being held in place by

the line bracket (Fig. 12).

b. Using the holes in the bracket as a guide, pre-

drill two (2)

⁄8

" holes from under the bottom of

the rail up through the top rail. Drive two (2) 1

⁄8

screws up through the hole locking the bracket,

panel and top rail together, being careful not to

drill through the top of the top rail (Fig. 13).

c. Install pyramid post top onto each post (Fig. 14).

NOTE:

A rubber mallet may be needed for a proper t.

Fig. 11

Fig. 12

Bottom Bracket CoverBottom Bracket Cover

Fig. 14

Pyramid TopPyramid Top

PostPost

Fig. 13

Assemble rail panels as described in "Rail

Installation."

NOTE:

• Taller posts (sold separately) may be

needed for either bottom or top of the stairs,

depending on the angle of the stairway or

the location of where the posts will be

installed relative to the nose of the stair

tread. Bottom stair posts may also be

moved out from bottom step (Fig. 1).

See "Post Installation" section for "Deck/Wood

Surface Installations."

STAIR RAIL INSTALLATION

Fig. 1