Instructions / Assembly

3
2.
Post Location:
Measure the width of the fence panel (X) plus the
width of the post (Y). This is the common center-
to-center measurement (unless there is a cut-down
panel) for post hole location (Fig. 2).
Post Installation:
Dig rst two post holes in diameter based on size
chart below* and down to your specied frost line.
Insert ller/gravel into the bottom of both holes and
then set rst post in post hole.
Add wet or dry concrete mix according to the
manufacturer’s instruction to the top of the hole for
rst post only and level it.
Example: When your frost line is 36" insert 12"
of gravel/ ller and 24" of post withconcrete
surrounding (Fig. 3).
Diameters based on post size:
10" for 5" x 5" post
8" for 4" x 4" post
Fig. 2
5x5 Post 5x5 Post
Example:Example:
Frost Line
Gravel/
Filler
10"
X+Y
YX
Fig. 3
3.
Insert 6" of gravel/ller into the bottom of both holes
and then set both posts into the ground and level
the rst post.
Add wet or dry concrete mix according to
manufacturer’s instructions to the top of the rst
post hole (Fig. 4). Make sure panel will be 2" above
the ground.
After setting rst fence section, proceed
systematically with post, panel, post, etc.
Fig. 4
Post
Concrete
Gravel
1.
Mark the fence location using string and line
stakes (Fig. 1).
NOTE:
Plan gate placement, opening and hardware
clearance before installing fencing.
Fig. 1
*