Instructions / Assembly

Installation Instructions for Hisun Snow Plow

1. Remove all components from the shipping carton and lay them out for easy reference.

2. Refer to the attached diagram below and find the following parts: #19 (Locking Plate), #20

(Mid Positioning Plate), and #21 (Swivel Plate).

3. As shown in picture, install the parts #19, #20, #21 on the bracket #22 in the order shown.

Secure part #11 (Setting Spring Bolt) bottom upward, while other 5 bolts should be

assembled from the top downward. In addition to the other washers shown, it is also very

important to note that there are (6 quantity) #17 (Washer 8mm) between part #20 and

part #22. Use the #16 bolts, #17 washers, and #18 Lock nuts to secure the parts #19,

#20, and #21 to the #22 (Main Push Tube). Secure the lock nuts tightly.

PAGE 1
Installation Instructions for Hisun Snow Plow 1. Remove all components from the shipping carton and lay them out for easy reference. 2. Refer to the attached diagram below and find the following parts: #19 (Locking Plate), #20 (Mid Positioning Plate), and #21 (Swivel Plate). 3. As shown in picture, install the parts #19, #20, #21 on the bracket #22 in the order shown. Secure part #11 (Setting Spring Bolt) bottom upward, while other 5 bolts should be assembled from the top downward.
PAGE 2
4. Use the part #15 (Adjust Handle and Wench Hook Pin) to connect part #10 (Adjusting Handle), part #14 (Hook for Wench Connection) with part #19 (Locking plate). Note 2 #12 (Washers 10mm) must be placed on the outside edges of the #14 (Hook for Wench Connection) before the #15 pin is inserted through the #10 (Adjusting Handle). Use the #13 (Cotter Pin) to secure the #15 pin. Bend the ends of the #13 (Cotter Pin) to secure #10 Pin. 5.
PAGE 3
10. Note: The 400, 500 and 700 UTV’s use the same mounting plate. However, the 500 and 700 have built-in nuts welded on the other side of the front plate. 11. Use 2 pcs #25 (Bolt 10mm x 40mm), 2 pcs #26 (Split Washer 10mm), and #27 (Washer 10mm) to attach the #23 (Bracket Mounting Plate) to the front plate of the frame. 12. On the 400 you will have to reach behind the front plate and hold the nut in place while the mounting bracket is being attached to the UTV.
PAGE 4