Instructions / Assembly

Brief recommendations and requirements during mounting of a PVC
window/door system
1. Doorway for mounting of PVC door/windows must have proper geometry.
Mounting must be made on the previously thoroughly prepared surface;
2. Window or door frame have to be installed on the bottom load-bearing pads. By
using spacer pads and, temporary installed wedges, door or window block is setting up
to the project position;
3. Load-bearing pads must be made from material which can withstand the loads,
which acts on the windows or door and transmit them on the wall constructions.
Position of such pads shouldn’t interfere to linear thermal expansion of the door or
window blocks;
4. Load-bearing pads-linings are located at the corners of the frame (under the rotary
hangers), in the area of bars and vertical mullions. Support pads must be installed
on the distance 150mm-200mm from the internal corners of the frame. Wherein
length of such pads must be not less that 100mm and width more that support
profile but less than width of the window/door frame;
5. For measurement verticality and horizontality of the installed windows or doors
preferable to use laser level. Final measurements have to be done with 1mm
accuracy. Vertical tolerance in the plane of the construction has to be less than 2mm
per 1000m of height, but not bigger than 3 mm per all length. Horizontal tolerance
has to be less than 2mm.
6. For providing required transmission of the loads, fastening of a door/window must
be done only by mechanical way. For fastening of the window/door blocks
prohibited to use polyurethane foam or another glue material;
During installation of the mechanical fastening elements must be keep the next
rules:
- The hole must be drilled, prohibited to use percussion instrument (exception –
concrete wall);