Operation Manual

GB
MC
1.0
18
6.1.2. Setting up / entering your home or basis altitude
Step 1: By pressing ALTI call TRIP ALTI in the display. Push MODE1 for 3 sec ENTER HOME ALTI TUDE and its previous value will be displayed.
Step 2: By pressing MODE2 the previous value is increased. Hold down the button to quickly scroll. By pressing MODE1 the previous value is decreased. 
Hold down the button to quickly scroll. Display capacity from -300 to +6000 meters / -984 to +19685 feet.
Step 3: Once you have entered your home altitude, terminate set-up by pressing ALTI for 3 sec. TRIP ALTI information will be back in display. Depending 
on the home altitude entered the actual altitude may read out differently.
6.1.3. Re-calibrating the altimeter to absorb changes in barometric pressure
Changes in barometric pressure make your VDO MC 1.0 change the readout of the current / actual altitude. This new readout may differ from the value you
have determined for your home altitude (= same location but changed barometric pressure). So before you go out for a ride, readjust the actual displayed altitude
to your home altitude. The easy-to-use re-calibration feature allocates the changes in barometric pressure to the home altitude you have entered.
Step 1: Get TRIP ALTI in display
Step 2: Press Mode 1 for 3 sec will bring “ENTER HOME ALTITUDE in Display
Step 3: Press Mode1+Mode2-button for 3 sec.
Automatic recalibration of actual air pressure to your home altitude setting will be done, after that the display will show TRIP ALTI again.