Manualshelf

Installation Guide

ManualsBrandsVaxcel Lighting ManualsChandeliersKedzie 9 Light 32" Wide Taper Candle Chandelier
12
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
H0260
Hardware Package (included):
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box
200827
Installation Steps
Upper Rod
Threaded Pipe
Threaded Pipe
Middle Rod
Lower Rod
Threaded Pipe
Threaded Pipe
Fixture Canopy
Bolt Nut (D)
Mounting Strap Unit (A) Mounting Screw (B) Wire Connector (C) Bolt Nut (D)
Outlet Box
House Ground Wire
Wire Connector (C)
Mounting Strap Unit (A)
Fixture Mounting Screw
Green Ground Screw
Mounting Screw (B)
1. Adjust the outer arms to the right angles.
2. Secure rods into the couplings of the light.
3. Attach the mounting strap unit (A) to the outlet box using
two mounting screws (B).
4
. Rod Connections:
a. Thread the fixture wires from the fixture through the lower rod,
and then secure the lower rod onto fixture using the threaded pipe.
b. Thread the fixture wires through the middle rod, and then secure
the middle rod onto the lower rod using the threaded pipe.
c. Thread the fixture wires through the upper rod, and then secure
the upper rod onto the middle rod using the threaded pipe.
d. Thread the fixture wires through the fixture canopy, and then secure
fixture canopy onto the upper rod using the threaded pipe.
Note: Height adjustable from 31-3/4" to 73-3/4".
Use fewer rods if shorter length is desired.
5. Pull out the source wires from the outlet box. Make wire
connections using wire connectors (C) as follows:
---Connect the smooth-coated wire (marked) from the fixture to
the black wire from the power source.
---Connect the ribbed-coated wire (unmarked) from the fixture to
the white wire from the power source.
---Attach the fixture ground wire to the mounting strap unit (A)
with the green ground screw, then connect it to the house
ground wire with a wire connector (C).
Carefully put the wires back into the outlet box.
Coupling
Outer Arms
Rod
Bulb Type B Max.60W
(not included)

Summary of content (2 pages)