Use and Care Manual

Installation step diagram
POP UP TOP
INTERNAL BRASS PIECE (POP UP MECHANISM)
RUBBER WASHER
DRAIN ASSEMBLY
WASHER
POP UP DRAIN TOP
INTERNAL BRASS PIECE
(POP UP MECHANISM)
COUNTERTOP
Ø1 3/4"
RUBBER WASHER
SINK
COUNTERTOP
SOFT WHITE WASHER
WHITE PLASTIC WASHER
TO DRAIN
POP UP DRAIN
SOFT WHITE WASHER
DRAIN NUT
DRAIN NUT
(with stand installed)
WHITE PLASTIC WASHER
TAIL PIECE
NOT PROVIDED
TAIL PIECE NUT
TAIL PIECE
Cleaning and Maintenance
Because resin is a very durable non porous material, resistant to scratches, stains and discoloration,
it is very easy to maintain, however, there are a few do's and don'ts that will ensure that your tub does
not loose its luster throughout the years.
If your basin dev
elops minor scratches they may be removed by scrubbing gently with the fine grit sand
paper, a soft brush or a non-abrasive sponge and a mild abrasive cream cleaner, in addition,
should the minor scratches remain or you would like to polish the area in question to its original finish,
you can perform the following procedure.
Gloss Finish
Matte finish
soft dry cloth
Microfiber cloth sand paper
!
DO NOT OVER TIGHTEN THE DRAIN
●Do clean it with a soft dry cloth after use.
●Do not use abrasive cleaners, cleaners containing acid, alkali or ammonia to remove stains.
●Do not expose the surface of this tub to hair dye or nail varnish as this may cause stains.
●Clean the surface with water, making sure no dust remains.
●Using water, polish the area starting with 800 grit sand paper, then 1500 grit and finally 2000 grit,
if a finer finish is desired you can give it a final sanding/polishing with 3000 grit sandpaper.
●Dry using a clean dry cloth.
●Wipe up the remaining wax with a clean and dry cloth.
●Clean the surface with water, make sure no dust remains.
●Using water, polish the area starting with 800 grit sand paper,
●Wipe up the remaining wax with a clean dry cloth.