Specifications

9479803
Using an RJ-45 connector, connect speaker audio
(Tip and Ring) and speaker power to board
mounted connector as shown on connecting
diagram.
All connections should be made to the mixer and
double-checked prior to connecting DC power.
Refer to Figure 3 to connect the message active
contact and remote activation of the messages. A
remote mounted connecting block will be required
to access these connections. Figures 4, 5 and 6
show connections to various types of Valcom
equipment.
Programming the Message Panel
Refer to the programming guide included with the
message panel documentation.
System Troubleshooting
There are 4 LED’s located on the PC board for
system troubleshooting. They are:
• LED D9 Mic. Switch Fault (ON = a fault is
being detected)
• LED D10 DC Fault (low battery or internal
monitoring
System fault) (ON = a fault is being detected)
• LED D11 Audio loop back fault (ON =
Fault in Mic. audio or 30Hz amplifier loop
back)
• LED D12 Flash Memory Error (ON =
Flash checksum failed
TECHNICAL ASSISTANCE
When trouble is reported, verify the unit is
turned on and there are no broken
connections leading to the unit.
Assistance in troubleshooting is available from
the factory. When calling, you should have a
VOM and a test set and call from the job site.
Call [phone] and press 1 for Technical
Support, or visit our website at
http://www.valcom.com.
Valcom equipment is not field repairable.
Valcom maintains service facilities in
Roanoke, VA. Should repairs be necessary,
attach a tag to the unit clearly stating company
name, address, phone number, contact
person, and the nature of the problem.
Send the unit to:
Valcom, Inc.
Repair and Return Dept.
5614 Hollins Road
Roanoke, VA 24019-5056
LIMITED WARRANTY
Valcom, Inc. warrants its products to be free from defects in materials and workmanship under conditions of normal use and
service for a period of one year from the date of shipment. The obligation under this warranty shall be limited to the replacement,
repair or refund of any such defective device within the warranty period, provided that:
1. Inspection by Valcom, Inc. indicates the validity of the claim;
2. the defect is not the result of damage, misuse, or negligence after the original shipment;
3. the product has not been in any way repaired by others and that factory sealed units are unopened (a service charge plus
parts and labor will be applied to units defaced or physically damaged);
4. freight charges for the return of products to Valcom, Inc. are prepaid,
5. all units “out of warranty” are subject to a service charge. The service charge will cover minor repairs (major repairs will be
subject to additional charges for parts and labor).
This warranty is in lieu of and excludes all other warranties, expressed or implied, and in no event shall Valcom, Inc. be
liable for any anticipated profits, consequential damages, loss of time or other losses incurred by the buyer in connection
with the purchase, operation, or use of the product.
This warranty specifically excludes damage incurred in shipment. In the event a product is received in damaged condition, the
carrier should be notified immediately. Claims for such damage should be filed with the carrier involved in accordance with the
F.O.B. point.
Headquarters:
Valcom, Inc.
5614 Hollins Road
Roanoke, VA 24019-5056
Phone: [phone]
Fax: [phone]