Installation Sheet

ManualsBrandsUttermost ManualsChandeliersLyndhurst 9 Light 38-1/4" Wide Chandelier

STYLE#

21321

ASSEMBLY INSTRUCTIONS

Carefully unpack all lamp parts from the carton.

Take the lamp carefully out of the carton, and place it on a flat surface.

Be sure the power to the installation point is powered off.

3. Adjust cord to desired length for your ceiling height. Cut and remove excess cord.

Thread

Nipple#2

on the bottom of the

Rod

onto the

Rod Base,

then secure it with

Finial Screw

. Hand tighten until

sung. Secure the rest eight rods the same way.

Fasten the

Cross bar

to the outlet box. Locate the

Washer

and

Nipple #1

, then thread them into the center of the

Cross

Bar

6. Secure

Nipple #1

onto the

Canopy

with

Loop#1.

Thread

Loop #2

onto

Nipple #2

. Hand tighten until sung.

Connect the

Chain

and

Loop #1

with

Quick Link #1,

then connect

Loop #2

with

Quick Link#2

Pass supply wire through

Loop #2

and Q

uick Link #2

, then wind onto the

Chain

and thread from the center of the

Cross

Bar

10.

The power supply wire consists of three wires, one black wire, one white wire and one silver ground wire.

11.

Connect the wires as shown: A. Connect the House Ground Wire to the Fixture Ground Wire.

B. Connect the House White or Ribbed Wire to the Fixture Supply Wire (White or Ribbed Side).

C. Connect

the House Black/Red Wire to the Fixture Supply Wire (Black or Smooth Side).

D. Wrap each connected wire with Wire Connector and carefully stuff all of the connected wires into the Outlet Box.

12.

Adjust each

Wire

to a natural bendingsituation.

13.

Install correct

Bulbs

referring to fixture markings and/or labels for maximum wattage. (Bulbs Included)