Manual

W A R N I N G
Never fire a double-trigger combination rifle/
shotgun by using two fingers because you
may inadvertently pull both triggers at the
same time resulting in a near simultaneous
firing of both barrels. Use your index finger
to pull one of the triggers to fire the first shot.
After that shot is fired, release the trigger and
move your index finger to the other trigger to
fire the second shot.
The Forend: The forend is the wooden grip piece
that attaches to the barrel assembly and locks the
barrel assembly into the receiver. See Figure 11.
The forend has a mechanical latch which is used to
lock and unlock the forend to the barrel assembly.
Never attempt to fire your combination rifle/shotgun
without having the forend locked in its proper position
on the barrel assembly.
The Serial Number: The combination rifle/shotgun’s
serial number is located on the top of the receiver
underneath the top lever.
Front Sight: Elevation adjustable. See Figure 12.
Rear Sight: Windage adjustable. See Figure 13.
Scope Mount Rail: 11mm scope rail included for
use with 11mm rings. See Figure 14.
W A R N I N G
Never adjust sights or scope mounts on a
loaded firearm. The firearm should be
completely unloaded before any such
adjustments are made.
Directions For Assembly Of Combination Rifle/Shotgun:
W A R N I N G
Before you begin to assemble the combination rifle/shotgun, you MUST
(1) look down the barrels from the breech end toward the muzzle end
to make sure there is no ammunition in the chambers or obstructions
in the barrels, and (2) make sure the safety is in the “safe” position.
Your combination rifle/shotgun was shipped with the barrel assembly (barrels
12
Figure 11
Figure 12
Figure 13
Figure 14