Instruction Manual

3) After inspection, load

the correct type of

cartridge into the

chambers making

sure that the

cartridges are flush

with the extractor.

See Figures 21 and

22. Then close the

action by swinging

the barrels up until

they lock into the

receiver. The locking

latch should move to

its fully locked

position. See Figure

23. If the locking lever

does not move to the fully locked position break open the action again and

check to see if the cartridges are fully seated in the chambers. If the cartridges

are fully seated then re-close the action. If the cartridges are not fully seated

check the chambers for blockages and check the cartridges for deformation

and retry closing the action once more. If the cartridges are the correct type

and the chambers are not blocked and the cartridges are not deformed and

the locking lever does not move to its fully locked position (See Figure 24)

unload the gun (follow Unloading Instructions) and have a competent

gunsmith look at the gun or return the gun to Spartan Gunworks



for

inspection. Do not force the rifle closed.

TO UNLOAD:

1) Break open the rifle by

depressing the

locking lever and

tipping the barrels

down. See Figure 25.

2) Remove the cartridges

from the chambers by

grabbing them by the rims of the cartridges and pulling them from the

chambers. See Figure 26.

Figure 21 Figure 22

Figure 23

Figure 24

Figure 25

Figure 26