Specification
3260 WALK-IN BATHTUB
32” x 60”
It is vital that tub is completely level with all leveling feet touching the floor for the door, seal and drain to work properly.
Key Attributes
Walk-in Type: ....................................... Walk-in
Material: ................................................ Acrylic
Soaker Weight: .................................... 140 lbs
Jetted Weight: ..................................... 180 lbs
Average Fill Capacity*: ..................... 60-70 gal
*Estimated with occupant inside. May vary based on occupant’s volume.
Required Electrical Service 110v
Air Bath or Whirlpool ......................... 1x 15 amp GFCI
Whirlpool w/ Inline Heater .............. 1x 20 amp GFCI
Whirlpool & Air Jetted ....................... 1x 20 amp GFCI
Soaker ..................................................... n/a
Available Therapy Systems
3260**S ...............................Non-Jetted Soaking
3260**H ..............................Whirlpool Jetted
3260**A ..............................Air Jetted
3260**D ..............................Whirlpool & Air Jetted
Key Measurements (inches)
Overall Outer: ...................59.625 x 32 x 40
Interior Width: ..................25
Standing Area: .................29.5 x 22
Seat Width: ........................22.25
Seat Height: ......................17.25
Soaking Depth: ................34
Drain to Side Wall: ..........11.25
Drain to Back Wall: ..........9.25
Step-in Height: ................7
Door Clearance: ...............14.5
Faucet Deck: ......................4.5
Tile Flange: ......................... 1
Extension Kit: ....................n/a
• IMPORTANT! TEST THE TUB’S DRAIN AND JETS (if any) BEFORE PERMANENT
INSTALLATION!
• INSPECT THE TUB WHEN RECEIVED! Report any damages or missing parts
within 5 business days of delivery date.
• Before ordering or installing, please consider future access to equipment.
• Please measure tub on-site before building tub surrounding!
• Jet, pump & blower locations are predetermined and cannot be changed.
• Tub door must remain closed when not in use.
v5 / 201905. All rights reserved. Subject to change without notice.
• Please note that installer(s) must be certied or warranty will be voided.
• Measurements are subject to a +/- .5” variance and subject to change without
notice. Measurements here in supersede all other published specs prior to
publication date shown below.
• Inline heater (if included) is designed to maintain water temperature during
operation. It will not heat cold water to desired bathing temperature.
• Product must be registered for warranty activation. See user manual or visit
SWCORP.com/register for more information.
SOAKING
DEPTH
Compliance: Uniform Plumbing Code
UPC®;; International Plumbing Code IPC®;
ADA
Standards: ASME A112.19.15; CSA C22.2
No. 218.2-15; UL 1795, 5th Edition Issued
September 02, 2016 including revisions
through August 25, 2017
Certifeid: UPC,EGS