Installation Guide

RAMPART WALL - Total Wall Surround Installation
5701 NW 35th Ave. Miami, FL 33142 • 1-877-360-4454 • www.UNIVERSALTUBS.com
INSTALLATION
APPLYING THE ADHESIVE TAPE AND SILICONE
Lay down the piece on a flat surface.
Note: Make sure to place a large cloth or piece of cardboard between the panel piece and the surface to
prevent scrapes and scratches.
Place the panel piece on the surface (facing downward) and begin laying down the adhesive tape. Lay down
3-4 evenly spaced strips along the full height of the panel. Peel off the protective lining from the adhesive
tape.
Next apply a liberal spread of silicon all along the areas surround the adhesive tape (including the spaces
between the tape and panel’s edge).
It is recommend to cut a ¼” hole at the tip of the caulking gun’s cap.
Rear view of Back Wall Panel
Example 60 by 60 in.
Rear view of one Flancking Panel
Rear view of
Corner Panel
Example 30 by 60 in. cut