User Manual
Table Of Contents
- Notice
- Chapter 1 Introduction
- Chapter 2 Hardware and Command Interface
- Chapter 3 Getting Connected
- Chapter 4 Managing Programs
- Chapter 5 Customizing PA500
- Chapter 6 Regulatory and Safety Notices
- Index
Chapter 3 Getting Connected34
Infrared Connection
The infrared (IR) port allows you to synchronize information with an
infrared-enabled computer. Simply align the infrared port of your device
with that on the computer. This method is ideal for quickly switching
between multiple devices since there are no cables or adapters to change.
1 Perform the steps below on your computer.
(1) Configure an infrared port on your computer following the
manufacturer’s instructions.
(2) Once your computer’s IR port is ready, open ActiveSync.
(3) Click File, then Connection Settings.
(4) Under the “In the Allow serial cable or infrared connection to this
COM port” list, select Infrared Port (IR).
(5) Click OK.
2 Perform the steps below on your device.
(1) Align the IR port of your device with that on your computer so that
they are unobstructed and within close range.
(2) Initiate connection by tapping Start > ActiveSync > Menu >
Connect via IR.
(3) Tap Sync.