Installation Guide
Determining Your Build Out Area (continued)Determining your threshold conguration
2
Glass Removal
If your door includes glass,
remove it before you start the
installation procedure. Loosen (do
not remove) each screw. Carefully
hold the glass panel in place and
rotate each clip 90°. Carefully
remove the glass panel and store it
in a safe place during installation.
Handleset Attachment
Following the manufacturer's
instructions, install your choice of
2-3/8" backset handle and lock set
(Sold separately). Fully extend the
lock bolts into the "locked" position
on the security door (B).
Rotate
clips 90°
Look at your existing entry door threshold and use the diagrams below to determine which threshold conguration best
applies to your entryway. This will determine whether a bottom bar is or is not required for your security door.
The existing threshold sticks out
beyond the trim by 3/16" or less.
The concrete and threshold sets
back behind the trim.
The concrete is set back and lacks
space to mount to the threshold plate.
The existing threshold extends past
the trim between 3/16" and 7/8".
Bottom Bar NOT RequiredBottom Bar Required
The concrete extends at least
7/8" further than your trim.
The existing threshold extends
beyond the trim by 7/8" or more.
Determining Your Build Out Area (continued)Preparing your security door
3