Owner's Manual

[24] USING THE SPEED DIAL MEMORY www.uniden.com
4) Enter a name according to the instructions below, then press the select key. If no name is
required, go to step 5.
• The name can be up to 13 characters.
•Use the #/→ and
*
/tone/← keys to move the cursor to the desired location.
•Use the delete/channel key to delete characters as needed.
• Press and hold the delete/channel key to delete all the characters.
Refer to the letters on the number keys to select the desired characters.
With each press of a numeric key, the displayed character appears in the following order:
Upper case letters first, lower case letters next and finally the number corresponding to
the key.
If you make a mistake while entering a name
Use the
*
/tone/← or #/→ key to move the cursor to the incorrect character.
Press the delete/channel key to erase the wrong character. Then enter the correct
character. To delete all characters, press and hold the delete/channel key.
For example, to enter Movies.
1) Press 6. Then press the #/→ key to
move the cursor to the right.
2) Press 6 six times.
3) Press 8 six times.
4) Press 4 six times.
5) Press 3 five times.
6) Press 7 eight times.
Number of times key is pressed
keys 1 2 3 4 5 6 7 8 9
2abc
3def
4ghi
5jkl
6mno
7pqrs
8tuv
9wxyz
0
1
oper
If the next character
uses the same number
key, you must press the
#/→ key to move the
cursor over. Otherwise
the next time you press
the number key, it
changes the character
that was previously set.
note
USING THE SPEED DIAL MEMORY
UP033BH_EXI7246C.book 24 ページ ２００４年１月１５日 木曜日 午前１１時４７分