Owner's Manual
Table Of Contents
- Welcome/Features
- Controls and Functions
- Terms Used in this Manual
- Accessibility
- Installing the Phone
- Register Handsets to the Main Base before Using!
- When to Re-register Handsets
- Basic Setup
- Using Your Phone
- Using the Speed Dial Memory
- Caller ID and CIDCW (Caller ID on Call Waiting)
- The Integrated Answering Device
- Setting Up Your Answering System
- Answering System Setting
- Setting the Time
- Setting a Personal Security Code (PIN)
- Setting the Ring Time
- Selecting the Message Record Time
- Setting the Message Alert Tone
- Selecting the Language
- Setting Your Outgoing Message (Greeting)
- Setting the Main Base Ringer Volume
- Temporarily Mute the Main Base Ringer and Call Screen
- Adjusting the Speaker Volume Level
- Turning the Answering System On/Off
- Using Your Answering System
- Changing the Digital Security Code
- Note on Power Sources
- General Information
- Troubleshooting
- Precautions & Warranty
- I.C. Notice
- Index
- Remote Operation Card
- At Uniden, we'll take care of you!
SETTING UP YOUR ANSWERING SYSTEM[ 36 ] www.uniden.com
Setting the Ring Time
The ring time setting allows you to set the number of rings the caller hears before
your answering system plays the outgoing message. You can set the ring time to
answer after two, four, or six rings. If you select Toll Saver [ ], the answering
system picks up after two rings if you have new messages, and after four rings if
there are none. This way, if you make a long distance call to check your messages,
you can hang up after the second ring to avoid billing charges.
1) With the phone in standby mode, press the
menu/clock key three times.
You hear “Ring time” and the current ring time ([ ], [ ], [ ], [ ] Toll
saver), and it is displayed on the main base. Then you hear the guidance for setting
the ring time.
2) Press the
volume/select/ or key until the desired ring time appears.
3) Press the
set key to select the new ring time. You hear a confirmation tone, then
the announcement “Ring time” followed by the new ring time. After a few
seconds, the system announces “To set record time, press menu again.”