Installation Guide

Latch Housing
Mounting Base
Rotate
Mounting Base
Remove 4
Screws
Button Housing
Mounting Base
Spindle
Button
(Do Not
Rotate)
Spring
Screws
Spring In Spindle
and Button
STEP-1
The KLX2-P2 is designed to fit both right-hand and left-hand applications. To conform to your application the latch and
button assembly may need to be reversed.
PLEASE CAREFULLY READ ALL OF THE
INSTRUCTIONS PRIOR TO INSTALLATION
To reverse the latch assembly: remove the four screws holding the mounting base, carefully lift and rotate the •
mounting base 180 (Fig #1) and fasten with provided hardware.
IMPORTANT: INNER COMPONENTS MUST NOT BE DISTURBED WHILE REVERSING THE ASSEMBLY.
To reverse the button assembly: remove the four screws, mounting base, spring, and spindle from the button as •
shown (Fig #2). Rotate the mounting base and spindle 180
. Reinstall components in the reverse order, (reverse
order of Fig #2), to insure proper functionality: 1. Slide spindle in the provided slot of the button (Refer to Step 2 if
spindle must be cut) 2. Insert spring into the bent portion of the spindle and place inside rear of button. Make
sure the spring seats on mounting base spring bump (not shown) and rests against the spindle 3. Finally, insert
mounting base (make sure spindle slides through provided slot of the mounting base) and fasten with provided
hardware.
IMPORTANT: INNER COMPONENTS MUST NOT BE DISTURBED WHILE REVERSING THE ASSEMBLY.
FIG. #1
Latch Assembly
FIG. #2
Button Assembly
www.nationwideindustries.com
INSTALLATION, ADJUSTMENT AND MAINTENANCE INSTRUCTIONS
GATE LATCH
KLX2-P2
10-29-2015 BY: DL
SHEET 1 OF 2
REV. 00