Installation Instructions

Mirror (18-7/8”W x 18-7/8”W, x 1)
For Mirror Installation:
2” Screws (x 2)
Drywall Anchors (x 2)
Vanity Top x1
Vanity Base x1
OVERALL DIMENSIONS of Cabinet
with Vanity Top:
33-1/1”H x 24”W x 14-1/4''D
Faucet and drain not included.
Verona Vanity Combo Set
SKU 6050049, 50, 51
Installa on Instruc ons
Tools required for assembly:
(A) Philips Screwdriver
(B) Silicone
(C) Tape Measure
(D) Level
(E) Electric drill with #2 drill bit and Phillips drive bit
Estimated installation time: 2-1/2 hours
(including removal of old vanity if applicable)
Included accessories:
WARNINGS & CAUTIONS
CARE & MAINTENANCE
WARNING: • To maintain the beauty of the furniture finish, avoid placing the
Two people are required for safe installation. Take extra
precautionary measures to ensure
a secure grip on the vanity
base and top when lifting.
CAUTION:
• The bathroom floor and wall must be finished prior to
installation of the vanity base and top.
• Do not use water that exceeds temperatures of140°F/46°C.
• Do not place any sharp or abrasive objects on the bare surface
of the vanity top.
vanity in direct sunlight.
• Avoid exposing the vanity to extreme temperatures by installing
away from heat and air vents.
• Dust frequently with a clean, soft and dry cloth.
• Wipe away
any water or liquid spills on the vanity base immediately
with a clean, soft and dry cloth.
INSTALLATION
Step 1: Install the pads(AAx4) on the 4 corners of the bottom of the vanity. Then place the vanity in the desired position taking
into account the location of your plumbing.
Step 2: Level your cabinet from front to back and side to side. Use shims(not included) if necessary. Use level for
accurate reading as improper shimming may cause your vanity to wobble and become m
isaligned resulting in twisting of
the cabinet.
Step 3: Remove door handles (BBx2) that are pre-installed on the back side of the doors and re-install them on the front of
the doors with their original matching screws(CCx4) using a Phillips screwdriver.
Step 4: Install the shelf screws(DDx4) inside the cabinet, then put the shelf on the screws.
Step 5: Measure two correct hole positions on the wall according to the two holes on the back of the cabinet. Drill holes,
place the cabin
et to the wall according to the two holes, then put wall anchors(FFx2) in and drill screws (EEx2) into wall
anchors(FFx2).
Step 6: Place the vanity top centered on the cabinet. For additional stability, use clear silicone to secure the vanity top
onto the cabinet.
Step 7: Apply silicone sealant around the top of cabinet. Place and position vanity top on cabinet and let it cure.
Step 8: Align mirror by centering it to vanity and install mirror using wall anchors(HHx2) and screws
(GGx2). Measure two correct
hole positions on the wall according to the two holes on the back of the mirror. Drill holes, put wall anchors(HHx2) in and drill
screws (GGx2) into wall anchors them while leaving around 1/2' of the screw length outside. Hang the mirror on the screws.
AA x 4
EE x 2
BB x 2
FF x 2
CC x 4 DD x 4
GG x 2 HH x 2
Philips
Screwdriver
Silicone
Sealant
Tape
Measure
Level Electric Drill