Installation Guide

ManualsBrandsUnbranded ManualsDesk FansXchanger 12 in. 2-Speed Reversible Basement Speciality Fan

INSTALLATION INSTRUCTIONS

MODEL X2R

OWNER'S INSTRUCTIONS, DO NOT DESTROY

THIS DEVICE MUST BE INSTALLED BY A

QUALIFIED PERSON.

READ INSTRUCTIONS CAREFULLY PRIOR TO

INSTALLATION AND OPERATION OF THE XCHANGER.

REV. A 07/14

TJERNLUND PRODUCTS, INC.

1601 Ninth Street • White Bear Lake, MN 55110-6794

PHONE (800) 255-4208 • (651) 426-2993 • FAX (651) 426-9547

Visit our web site • www.tjernlund.com

Summary of content (8 pages)

PAGE 1
REV. A 07/14 TJERNLUND PRODUCTS, INC. 1601 Ninth Street • White Bear Lake, MN 55110-6794 PHONE (800) 255-4208 • (651) 426-2993 • FAX (651) 426-9547 Visit our web site • www.tjernlund.com MODEL X2R INSTALLATION INSTRUCTIONS OWNER'S INSTRUCTIONS, DO NOT DESTROY THIS DEVICE MUST BE INSTALLED BY A QUALIFIED PERSON. READ INSTRUCTIONS CAREFULLY PRIOR TO INSTALLATION AND OPERATION OF THE XCHANGER. Copyright © 2014, Tjernlund Products, Inc. All rights reserved.
PAGE 2
TABLE OF CONTENTS Descriptions and Specifications.......................................................................................................................................1 Installation Restrictions....................................................................................................................................................1 Cautions ..............................................................................................................................................
PAGE 3
Disconnect power supply to fans and/or accessory controls when reversing fan direction or servicing the XCHANGERTM. Failure to do so may result in personal injury and/or equipment damage. Make certain the power source is adequate for the XCHANGERTM requirements. Do not add the XCHANGERTM to a circuit where the total electrical load is unknown.
PAGE 4
XCHANGER OPERATION BASED ON AIR CHANGES PER HOUR This method of operation can be used to supplement or provide for guaranteed air change rates. Table 1 shows the constant Cubic Feet Per Minute (CFM) of air necessary to produce the desired Air Change Per Hour rate (ACH), assuming natural infiltration of outside air at a rate of .10 ACH. Square footage is determined by calculating the finished living space of the house. Garages and crawl space should not be included.
PAGE 5
DIAGRAM A INSTALLATION (TOOLS REQUIRED) • Reciprocating saw • Drill and 1/2” bit • 5/16” nut runner or socket • Phillips screwdriver • Siding tools (dependent on exterior finish) • Level INSTALLATION NOTE: Before cutting opening through wall, confirm XCHANGERTM hood termination clearances are met as noted on bottom of page 3. 1. A) Center X2R mounting template and tape to the rim joist between the floor joists/trusses XCHANGERTM will be mounted through, (See Diagram B).
PAGE 6
4. Insert XCHANGERTM hood backing plate through exterior wall with collars on inside of house. IMPORTANT: Make sure backing plate bent flange is on top facing out, (See Diagram G). For vinyl or other types of lap siding, level backing plate and trace around edges. Trim siding back enough to install J channel or appropriate flashing, (See Diagram E). 5. Place a bead of caulk on back side of hood backing plate or building sheathing before inserting backing plate, (See Diagram F). 6.
PAGE 7
12. WARNING: Unplug fans from wall outlet or accessory controls when changing fan direction to prevent damage or injury. Insert fans in desired direction for either exhaust or intake. See arrow on bottom of fan cartridge or side of fan shroud for air flow direction. Once installed confirm the air is being exhausted or supplied depending upon application, (See Diagram M). NOTE: Use optional DT2-6 kit if ducting on discharge side. 13.
PAGE 8
WHAT IS NOT COVERED Product installed contrary to our installation instructions Product that has been altered, neglected or misused Any freight charges related to the return of the defective part Any labor charges related to evaluating and replacing the defective part TJERNLUND LIMITED 1 YEAR WARRANTY Tjernlund Products, Inc.