Use and Care Manual

Timber Stoves Safety Cage

Instructions

____________________________________________________________________________

Please visit the Wood Pellet Products Youtube channel and watch the

Timber Stoves Safety Cage Assembly video

1. Unpack all parts and lay out panels. Remove all vinyl from parts.

2. Assemble the two bottom right and left pre assembled panels to the

middle baffle pan using three ¼-20 x ½” bolts. Front of the pan is

marked.

● Lay right bottom panel face first on a non abrasive surface.

● The middle baffle pan assembles with the flat side of the pan facing the base.

● Assemble the middle baffle pan to the right side panel using four ¼-20 x ½” bolts.

● Stand upright and install the bottom left panel.

● Attach the left bottom panel to the opposing side.

3. Place partially assembled cage onto patio heater. Attach using 1/4x1/2” bolts.

4. Install the solid back bottom panel by inserting over the hopper and onto frame between

the hopper and stove using 10/32x1/2” bolts.

5. Install the two door hinges to the frame of the heater using 10/32x1/2” bolts with

k-nuts(nuts with star shape on them).

6. Install door and door latch receiver (hook shaped latch with slot facing up and one hole)

using 10/32x1/2” bolts and k-nuts. Best to keep the hardware loose before tightening all

hardware on hinges.

7. Attach top left side panel to horseshoe shaped top collar. Opening faces back. Pan faces

down, flat side up. Tuck the top mesh into the interior side of the horseshoe shaped collar

and the bottom mesh into the interior of the middle baffle pan..

8. Attach top right side panel to horseshoe shaped collar using ¼ x 1/2 “ bolts. Tuck the

top mesh into the interior side of the horseshoe shaped collar and the bottom mesh into

the interior of the middle baffle pan.

PAGE 1
Timber Stoves Safety Cage Instructions ____________________________________________________________________________ Please visit the Wood Pellet Products Youtube channel and watch the Timber Stoves Safety Cage Assembly video 1. Unpack all parts and lay out panels. Remove all vinyl from parts. 2. Assemble the two bottom right and left pre assembled panels to the middle baffle pan using three ¼-20 x ½” bolts. Front of the pan is marked. Lay right bottom panel face first on a non abrasive surface.
PAGE 2
9. Attach front screen mesh panel to front top section of heater. Install before installing top back panel. Place hot symbol logo with 10/32 x ½” bolts onto open holes in middle of panel while securing mesh panel . Next place mesh over bolts and secure using k nuts. Finish by placing 10/32 bolts into remaining holes and secure with k-nuts. 11. Attach partially assembled top section of cage to heater attaching at middle baffle pan using ¼-20x1/2” bolts. 12. Attach Spring handle to the door.