Installation Guide

ManualsBrandsUnbranded ManualsBathClassic 2-Handle Deck-Mount Roman Tub Faucet with Hand Shower Trim Kit Only in Stainless (Valve Not Included)

Para instalación fácil de su llave Delta

usted necesitará:

•LEER TODASlasinstruccionescompletamente

antesdeempezar.

•LEER TODOSlosavisos,cuidados,e

informacióndemantenimiento.

•Paracompletarelbordeylainstalaciónde

válvulasdentrodelasparedespreviaala

instalacióndelallaveysusaccesorios.

For easy installation of your Delta

faucet you will need:

•ToREAD ALLtheinstructionscompletely

beforebeginning.

•ToREAD ALLwarnings,care,andmaintenance

information.

•Tocompletethedeckandvalverough-inpriorto

installingthistrimkit.

Pour installer votre robinet Delta

facilement, vous devez:

•LIRE TOUTESlesinstructionsavantdedébuter;

•LIRE TOUSlesavertissementsainsiquetoutes

lesinstructionsdenettoyageetd’entretien;

•Installezlecorpsdurobinetetterminezle

pourtourdubainavantdeposerlesaccessories

definition.

Models/Modelos/Modèles

T4705&T4705-25

Series/Series/Seria

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

You may need/Usted puede necesitar/Articles dont vous pouvez avoir besoin:

SILICONE

Icons

1/8"(3.17mm)

3/32"(2.38mm)

1/8"(3.17mm)

SILICONE

7/9/13   Rev.C

ASMEA112.18.1/CSAB125.1

TWO HANDLE ROMAN TUB TRIM

LLAVE Y SUS ACCESORIOS PARA

BAÑERA ROMANA DE DOS MANIJAS

(MANERALES)

ACCESSOIRES DE FINITION DE ROBINET

À DEUX POIGNÉES POUR BAIN ROMAIN

62090

3/32"(2.38mm)

www.deltafaucet.com

Summary of content (8 pages)

PAGE 1
62090 TWO HANDLE ROMAN TUB TRIM LLAVE Y SUS ACCESORIOS PARA BAÑERA ROMANA DE DOS MANIJAS (MANERALES) ACCESSOIRES DE FINITION DE ROBINET À DEUX POIGNÉES POUR BAIN ROMAIN ASME A112.18.1 / CSA B125.1 Models/Modelos/Modèles T4705 & T4705-25 Series/Series/Seria Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici. You may need/Usted puede necesitar/Articles dont vous pouvez avoir besoin: E ON LIC SI TE F LON 3/32" (2.38mm) 1/8" (3.
PAGE 2
Limited Warranty on Delta® Faucets Parts and Finish All parts (other than electronic parts and batteries) and finishes of this Delta® faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed or, for commercial users, for 5 years from the date of purchase.
PAGE 3
RP50858▲ Lift Rod Assembly Ensamble de la barrita de alzar Tirette RP6068▲ Button Botón Bouton RP46683▲ (2.0 gpm) Handpiece (Used on T4705) Pieza de Mano (Utilizado en en T4705) Douche à main (Utilisé sur T4705) RP62097▲ Handle Manija Manette RP62094▲ Handle Base w/Gasket Base de la Manija con Empaque Embase de manette avec Joint 59462-B-PK (2.
PAGE 4
A. B. 1 3 2 4 2 3 RP40668 Diverter Assembly Ensamble del Desviador Dérivation 4 1 2 1 Maintenance B. If faucet does not divert water from the spout to the hand shower, check that A. If faucet leaks from spout outlet–Shut off water supplies– the lift rod (1) is securely threaded into the diverter (2). If the problem persists remove the lift rod and spout. Replace the diverter assembly RP40668. Replace Seats and Springs (1) - RP4993.
PAGE 5
2 1 1/8" (3.17 mm) 1/8 po 6 5 8 9 1 3 1 1 7 2 2 3/32" (2.38 mm) 3/32 po 3 5 6 4 Screw bases (1) with gaskets (2) over end valves (3). Option: Use silicone under the gasket if deck is uneven. IMPORTANT: Remove orange lift rod retainer (4) prior to spout installation. To remove retainer, hold spout (5) firmly over flat surface and pull up on lift rod (6). The orange retainer should drop from bottom of spout. Properly dispose of retainer. Install spout (5) on adapter (7).
PAGE 6
3 C. A. 1 2 1 4 3 D. B. 1 1 2 C. Slide hose (1) through conical nut (2). Attach hose (1) to braided A. Turn / thread lift rod (1) until it drops down and rotates freely. metal hose (3) using gasket (4) and tighten. DO NOT install hand piece yet. B. Remove and discard the test cap and gasket (1). NOTE: This is an extra gasket, one is supplied with the hose. D. Install base (1) to nest (2) and tighten. OPTION: Use silicone under the base if deck is uneven. C.
PAGE 7
4 3/32" (2.38mm) Install handles. If either handle does not rotate in the correct direction, do the following: 1. Be sure that the end valves are installed correctly (with the hot valve on the LEFT and both inlet tubes installed AWAY from the spout). 2. Turn off the water supplies and remove the handle, bonnet nut, and stem unit. 3. Refer to the Maintenance Section (page 4) for correct stem unit orientation and reassemble. Instale las manijas.
PAGE 8
5 B. A. 3 1 2 2 3 1 2 A. Pull hose (1) to its farthest extension and point it down into the B. Attach hand piece (1) to hose (2) with gasket (3) between A. Hale la manguera (1) a lo máximo que se pueda extender y B. Conecte la pieza de mano (1) a la manguera (2) con el tub. Turn faucet handles (2) all the way on. Pull the lift rod (3) up to the full on position and flush the hot and cold water lines for one minute. After flushing turn off water at the bath valve handles.