Use and Care Manual

YOLI PRO 100 SET UP INSTRUCTION

SECURING THE CANOPY TOP TO THE FRAME

SET UP

THANK YOU FOR PURCHASING A YOLI INSTANT CANOPY!

Please carefully review the following instructions and familiarize yourself with parts included

and how to operate your YOLI canopy. Reference parts list for names of each part noted in instructions.

Parts Included: Fully Assembled Frame (1) Canopy Top (1) Carry Bag (1) Stakes (4)

Place the canopy frame in the desired location (Fig. 1A).

With partner, stand opposite side of the frame and hold the outer legs.

While holding the legs li slightly off the ground taking a few steps backwards

to extend frame at full arm’s length as shown (Fig. 2A).

Unfold the canopy top and place it over the open frame (Fig. 3A). Locate in the center of the eaves frame where

it forms a diamond shape a large slotted fastener as pictured in (Fig. 3B). Remove the fastener using a coin or screw

driver (if needed). Pull the canopy top over the eaves where the canopy grommet meets the screw head as pictured

in (Fig. 3D). Tighten the large slotted fastener to the screw head to secure the canopy top as pictured in (Fig. 3E).

Secure each corner by attaching the corner of the canopy top to the black fastening strip (Fig. 4A).

Pull all 4 corners down until completely over black fastening strip. Your canopy top is now secured to the frame.

Place the canopy in the desired location for shade. With partner standing on the opposite side of the canopy,

hold the outer legs and li slightly off the ground stepping backwards (Fig. 1A).

With partner hold the top and bottom of the middle of the eaves where it makes a diamond shape as

pictured in (Fig. 2A) liing slightly off the ground walking backward to extend the frame.

Be careful not to pinch your ﬁngers as the frame opens!

At the top of the leg, place one hand on the top corner pushing down and with the other hand just below the

latch slider liing up until it locks into position as pictured in (Fig. 3A). Repeat on other 3 legs.

1AFig. 3AFig. 3BFig. 3DFig. 3EFig. 4AFig. 2AFig.

1AFig. 3AFig. 4AFig. 2AFig.

With partner standing on the same side, li outer leg to slide out inner leg until the push button

clicks into place at desired height as shown (Fig. 4A). Repeat on opposite legs.

PAGE 1
THANK YOU FOR PURCHASING A YOLI INSTANT CANOPY! Please carefully review the following instructions and familiarize yourself with parts included and how to operate your YOLI canopy. Reference parts list for names of each part noted in instructions. YOLI PRO 100 SET UP INSTRUCTION Parts Included: Fully Assembled Frame (1) Canopy Top (1) Carry Bag (1) Stakes (4) SECURING THE CANOPY TOP TO THE FRAME 1 Place the canopy frame in the desired location (Fig. 1A).
PAGE 2
SECURING YOUR CANOPY: To harness your canopy to the ground, insert the included metal stakes into each foot corner. For additional stability, you can purchase from our Customer Support Center sand bags custom designed to secure quickly to each leg for additional weight to secure your canopy on any surface. TAKE DOWN 1 Stand on the same side as your partner. In tandem slightly lift leg and depress the push button to unlock the inner leg. Push inner leg into outer leg as shown in (Fig. 1A).