OWNER’S REFERENCE GUIDE
Zen Hot Tubs 121 S. 39th Ave. Suite 2 Phoenix, AZ 85009 866-939-0851 Many troubleshooting inquiries can be handled by your dealer by phone. Side panel removal allows easy access to all interior spa plumbing for easy inspection or repair, allowing for total jet accessibility in seconds rather than minutes. Most parts are readily available from the factory, if not already in stock at your local dealer. Quick Tip Guide 1.
Zen Hot Tubs Startup Selecting Zen Hot Tubs Site Location It is important your new spa be installed on a solid, flat, and level surface that is engineered to carry a load of 75 pounds per square foot. Spas should not be placed near or below electrical or telephone cables. If there is not a dedicated 120v receptacle within 10’ of your spa, contact a Licensed Electrician to supply power near the spa. A GFCI Power Cord is supplied with all 120v applications.
Care and Maintenance Instructions Cleaning the Filter Cartridge 1. 2. 3. 4. 5. 6. Disconnect power Remove the filter cover Unthread the Filter Cartridge counterclockwise Rinse dirt and debris away thoroughly with a garden hose Replace filter cartridge and cover Reconnect power Water Chemistry Read and understand the spa chemistry guidelines supplied by your dealer or local chemical supplier. There are many solutions available to balance your water chemistry.
Troubleshooting “Why Is My Spa Constantly Running?” All Zen Hot Tubs are fitted with state-of-the-art technology that automatically filter your spa as well as check to ensure the spa is always at the desired temperature. Part of this process is that the spa pump runs twice a day for at least 1/2 hour each time to filter. Additionally, the pump runs once every 30 minutes to verify that the spa is at the correct temperature.
DANGER: RISK OF ELECTRIC SHOCK Do not permit any electric appliance such as a light, telephone, radio, or television within 5 feet of a spa or hot tub.
IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS WARNING: BEFORE ENTERING THE SPA OR HOT TUB MEASURE THE WATER TEMPERATURE WITH AN ACCURATE THERMOMETER WARNING: DO NOT USE A SPA OR HOT TUB IMMIDIATELY FOLLOWING STRENUOUS EXERCISE WARNING: PROLONGED IMMERSION IN A SPA OR HOT TUB MAY BE INJURIOUS TO YOUR HEALTH WARNING: DO NOT PERMIT ELECTRIC APPLIANCES (SUCH AS A LIGHT, TELEPHONE, RADIO OR TELEVISION WITHIN 1.
Feature Function List BWG HJ81 BWG, Heat Jacket Control System, Model: HJ81 The HJ81 is “heat jacket” software. (It turns on the pump to heat; there is no separate heater.
Feature Function List BWG HJ81 • • Diagnostic message display - LCD screen ∗ Sensor failure detection - "Sn" ∗ Either high-limit or water temp overheat detection - "OH" High-limit protection 2 levels: software and hardware ∗ High-limit detection - "OH" at 118°F (Software) / at 116°F (Hardware) ∗ Panel button press required to reset high-limit “OH” fault at 112°F or below ∗ Water temp.
TO ALL ORIGINAL PURCHASERS OF THIS PRODUCT 5- YEAR WARRANTY Zen Hot Tubs warrants the entire spa shell surface against water loss and structural integrity due to defects in the spa for 5 years.