Installation Guide

CAUTION: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened rmly. Apply

weatherproof silicone sealant (NOT included) around the edge of the Wall Box and/or Junction Box. This is especially important with an

uneven wall surface. Silicone all plugs and unused conduit entries.

MOUNTING INSTRUCTIONS

IMPORTANT: READ BEFORE REMOVING FIXTURE FROM CARTON. RETAIN FOR FUTURE REFERENCE.

This xture must be wired and installed in accordance with the NATIONAL ELECTRICAL CODE and all state and applicable local codes

and ordinances. These codes and ordinances supersede any and all instruction contained herein. Installation should be performed only by

a licensed and bonded electrician and a person familiar with the construction and operation of the product and the hazards involved in the

installation and operation of this product. Proper grounding is required for safety. Make certain power is OFF before installing or maintaining

xture. Failure to do so may increase the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE, AND DEATH. The manufacturer takes no

responsibility for the product not installed under those guidelines and those contained in this document. See wiring diagram on back

SUITABLE FOR WATTAGES:

VER01.16

10W, 15W & 20W

OVERDOOR LIGHT

FIGURE 1

FIGURE 2

FIGURE 3

3.04’’ x 6.35’’ x 8.25’’

FIXTURE IS SUITABLE FOR WET LOCATION

MOUNTING INSTRUCTIONS:

1. REMOVE FRONT HOUSING Loosen two screws on the housing.

Remove front housing (FIG.1)

2. REMOVE REFLECTOR Loosen two screws enough to allow

reector to slide downward to remove reector (FIG.2)

3. J-BOX MOUNTING knock-out desires holes in rear housing. Place

gasket behind back plate and thread wires through back of xture

and make wire connections in j-box

4. MOUNTING WITH TWO BOLTS Knock out slug “C” in g. 3 and

drill out conduit entry hole. Place gasket between back housing and

wall and attach to wall using two screws. (FIG.3) Drill out bottom

conduit entry and thread wires into bottom conduit hole and make

wire connections (See wiring diagram)

5. REPLACE FRONT HOUSING Replace front housing by reversing

procedure used to remove it. (FIG.1)

PAGE 1
MOUNTING INSTRUCTIONS OVERDOOR LIGHT SUITABLE FOR WATTAGES: 10W, 15W & 20W 3.04’’ x 6.35’’ x 8.25’’ IMPORTANT: READ BEFORE REMOVING FIXTURE FROM CARTON. RETAIN FOR FUTURE REFERENCE. This fixture must be wired and installed in accordance with the NATIONAL ELECTRICAL CODE and all state and applicable local codes and ordinances. These codes and ordinances supersede any and all instruction contained herein.
PAGE 2
MOUNTING INSTRUCTIONS OVERDOOR LIGHT SUITABLE FOR WATTAGES: 10W, 15W & 20W (+) LINE BLACK (-) COMMON WHITE GROUND GROUND LIGHTING FIXTURE 3. Connect the black fixture lead to the (+) LINE supply lead (+) LINE BLACK (-) COMMON WHITE (+)DIM V+ PURPLE (-)DIM V- GRAY FIGURE 2 1. Connect the GROUND wire from fixture to supply ground 2.