MFG H A R TM USA D W A R E F L EU R D E LIS HANGER I N S TALLAT I O N I NST RU CT I O NS 7.26.
All measurements are shown in inches 17/8” 17/8” O 27/8” 33/8” 113/4” 31/2” PLEASE NOTE: These instructions are specific to a particular hanger size and type. Adjustments may be needed on your part for changes in specifications and measurements, as well as hanger types that are different than these.
Too l s N e e d e d Tape Measure Pencil Drill with 1/8”, 1/4” and 3/8” bits, 1-1/8” spade bit or Forstner bit and Phillips drill bit Short Level Ratchet with 9/16” and 5/8” sockets 9/16” and 5/8” open end wrench Pa r ts In cl u d e d Hanger Assemblies Track Adjustable Spacers Hard Stops Lag Screws Hex Bolts Acorn Nuts Anti-jump Brackets 1” Washers Grabber Screws Door Guide Instructions MFG H A R D U SA W A R E TM
How to Measure f or Your Door Size Doorways W i t h o u t Tri m Door Height Door Width Door Opening 1. The exact height of your door opening Adding 2” along either edge of your door opening to the actual width of your door allows your door to cover the door opening plus 2” of wall on either side for privacy 1. + 2-3/4” 2. Door Opening width of door opening + 2” = Door Height (where you will mark a horizontal line on your wall where you will hang your Track) 2.
Door bottom with mortise NOTE: If you are installing a Floor Mount Door Guide, your door will have a mortise (a groove that runs along the bottom of your door). Make sure this mortise is facing down towards your floor and that you install the Door Hangers on the other end. 1. Measuring a n d M a rk i n g Yo u r H a nger Hol es 2. Dri l l i ng Pi l ot Hol es Door Top Door Top • Lay your Door facing UP on saw horses.
5. Installing Your Hanger Assembly To Your Door 6. Ti ght eni ng Your Hanger A s sembl y • Using a 9/16” wrench for the Acorn Nut and a ratchet with a 5/8” socket and for the Hex Bolt, gently tighten, being careful not to damage your Hanger or Acorn Nuts. • Repeat Steps 5 and 6 on the opposite edge of the Door. • Thread the Hex Bolts with the Washers through the back of the Door. • Thread the Hanger assembly through the Hex Bolts on the front of the Door.
9. Hangi ng Your Track 8. Marking an d D ri l l i n g Tra ck H o l e s • Hold up your Track so that the marked line from the previous step is visible through the Track holes. • Mark an intersecting line in the center point of each of the Track holes. • Set the Track down. • Using a drill with 1/4” drill bit, drill out your marked Track holes.* *Be sure you are drilling into wall studs. If your track holes are not lining up with your studs, you will need to install your Track onto a header.
11. Installing Yo u r D o o r • Lift your Door up to your Track at a slight angle. • Carefully rest both Wheel grooves onto the top of the track. • Guide the Door to the resting position. The following are instructions for installing our Floor Mount Door Guide. If you are installing another type of Door Guide, go to www.rusticahardware.com and download instructions specific to your Door Guide. 1 2 . D oor Gui de Part 1 13. Door Gui de Part 2 • Use your level to plumb* your Door.
