Instruction Manual H.I.D Digital Ballasts 400W 600W 1000W All our ballasts are compatible with Safe Grow Hydroponic Smart System.
IMPORTANT PRODUCT INFORMATION READ IMMEDIATELY SAFETY FIRST! Failure to observe the following safety warnings may result in serious injury or death. Use all Hydro Crunch™ products only as directed. Failure to observe these safety warnings will result in a waiver of any and all liability on the part of Hydro Crunch™ its manufacturer, and resellers, and will void all warranties to the extent permitted by law. WARNINGS AND INSTRUCTIONS FOR USE: Disconnect power before re-lamping.
Features: Soft Start Technology ensures that lamp start-up is as lamp friendly as possible while maintaining consistent ignition. Randomized firing sequencing allows large ballast installations to be turned on simultaneously without taxing circuit breakers or switches. Specifications: Power Factor: 99% Input Voltage Range 100-265 VAC Crest Factor: 1.
Technical Information: 1. Remember to set the wattage dimming knob to 100% before starting up the ballast. It takes approximately 6 seconds to warm up to full intensity. Once the lamp is ready, you can dim the ballast as desired. However, allow the bulb to adjust after each turn during dimmer. Adjusting too fast may prevent full lamp and ballast efficiency. 2. Be sure to use the correct voltage cord if you are using a multi-voltage ballast.
400W BALLAST 400W BALLAST 600W BALLAST 120V 600W BALLAST 240V 1000W BALLAST 120V 1000W BALLAST 240V 120V SETUP: 240V SETUP: SETUP: SET UP: SETUP: SET UP: PLEASE MAKE SURE PLEASE MAKE SURE PLEASE MAKE SURE PLEASE MAKE SURE PLEASE MAKE SURE PLEASE MAKE SURE THERE IS 7 AMP THERE IS 5 AMP THERE IS 10 AMP THERE IS 7 AMP THERE IS 15 AMP THERE IS 10 AMP OF ALLOWANCE PER OF ALLOWANCE PER OF ALLOWANCE PER OF ALLOWANCE PER OF ALLOWANCE PER OF ALLOWANCE PER BALLAST/ BREAKER.
2 Year Limited Warranty Service If the product will not work after you have read the troubleshooting guide and practiced the troubleshooting options, you are advised to return the Hydro Crunch™ light system to the retailer you purchased it from. The dealer will be able to examine the light and test its components. If they are not able to repair the light, they will return it to us for examination and repair/replacement. Do not attempt to repair any product on your own, as serious injury or death may result.
