ASSEMBLY GUIDE f Note: This instruction booklet contains important safety information, please read and keep for future reference.
CAM LOCK SYSTEM aN i (1) CORRECT WRONG Ensure starting position is correct, adjust cam bolt by pushing or pulling during assembly. Turn clockwise until secure.
Note: This side faces the glass door, SR 5 gk (ULTRALIGHT ny {AMERICA BOLTHOLES Emmy (RESST2ZOXAZHOPCS en (ADJUSTABLE FOOTPATHS 0 light RY to cover board E with 2 screw bi Fasten 1 magnet Rd fo cover board E-with screw RS (ST2.9X12). fasten 4-cam bolt R2 to cover board E. fasten 1.magnet R4 to shelf board C'with 4 screw RS (5T2.8X12). g)Fasten 8 cam bolt RZ: to shelf billiard G. fasten 8 adjustable foot R11 10 back of base unit A: fastening 4d cam boil R2 fo base unit A.
(R3)CAM LOCK APES © {SHELLFIRE SUPPORT STUBS 8 shelf support stud RY to holes on left and right back panel BLT & BR1. Biathlon left and right back panel BLISTERY to base unit A Ci Fasten BLISTER to With 4 cam lock RS.
(CAMERA LOCKUPS Wy Guam 5, Hitachi cover board E to top left and right back panel BL2&BR2. b)Fasten E to BLZ&BR2 with 4 cam lock Ra. fasten BLY to BRT with 5 screw d)Fasten BL2 to BR2 with 5 screw Mote: the electronic wire must go through the groove on top right back panel BR2 first.
oh, {FIBERGLASS WHINGEING ai 8.4) Fasten 1 latch plat R10 and 1 glass hinge R80 the corner of 1 door D. The black washer should be attached rider the screws, bj Insert glass hinge RS into the botany tile on shelf board C. The black washer ort R8 should be attached under the S Crews.
(RB)GLASS HINGE 1PC £5 EN (HOURGLASS WHINGEING 50 3 (RIG LATCH PLATE PC Ni 9.8) insert glass hinge RY info the top hole on cover board E. b) Slide glass door I} inch place through RB as shows on drawing then fasten the S Crews, 10. Repeat the process for another door D.
E {RB)GLASS HINGE(PC Si (HOURGLASS HINGE oh (DISPATCHER TEMPLATE L I 11,a} Fasten 1 latch plate R1G and 1 flags hinge R8 to the corner of 1 door D. The black washer should be attached under the screws. by) Insert glass hinge RO into the bottom hale on shelf board ©. The black washer on RS should be attached under the Strews.
oh (GLASSWARE HINGES Si (HOURGLASS ETCHING oh (DISPATCHER TEMPLATE L I 12.3) Insert glass hinge RS into the top hole on cover board E. 1) Slide glass door D into plate through RY as showed on drawing then fasten the sowers, 13. Repeat the process for another door D., Note: You can through adjusting the hinge R8/RY to adjust the distance between doors io make sure the latch plate R10 can be connected on the magnet properly. lf R10 can't attach to door closely just squeeze it lightly, then fasten to door.
(PLASTICITY SCREW rE i} ANCHOR: 1PC order © ensure that the cabinet is stable adjust the adjustable foot under the cabinet.