FL-1000 Assembly Guide
Installation Location ➢ Select a location at least 6 inches or more after the main shutoff for the installation of the FL-1000 sensor. Make sure that the location you select in the main line after the shutoff valve is before the pipe branches off. Mounting and Installation (It is Strongly advised to contract a certified plumber) 1. Shut off the main valve that feeds the water to the house. See diagram 1 2. Cut a one inch piece out of the PEX water pipe. See diagram 2 3.
Pre-Delivery/Install Checklist 1) FL-1000 Leak/Freeze Sensor 2) 24 VDC power Adapter 3
Troubleshooting No Can you see the FL-1000 network on your smart device The unit is defective. Yes Can you connect to the FL1000 network with your smart device No Reboot the FL-1000 If after rebooting the unit you still cannot see the FL-1000 network or connect to it the unit is defective. Yes Try to connect to the FL-1000 User Interface.
Warranty and Disclaimers WARRANTY Mani Group warrants that each product will be free of defects in material and workmanship for a period of one (1) year for its products. The warranty commences on the date the product is shipped by Mani Group. Mani Group’s sole liability and responsibility under this warranty is to repair or replace any product which is returned to it by the Buyer and which Mani Group determines does not conform to the warranty.